Lewmar 22m Gen2 Control Cable

Upgrade Your Anchoring System with Precision Engineering

Picture this: you're anchoring in a secluded cove at dusk, waves gently rocking your vessel, and your windlass responds flawlessly to every command. The secret behind that seamless operation often lies in a reliable control cable like the Lewmar 22m Gen2 version. Designed specifically for marine environments, this cable ensures crisp, responsive signals from your deck control to the windlass motor, minimizing signal loss over distance and harsh conditions.

Crafted with marine-grade materials, it withstands saltwater corrosion, UV exposure, and constant flexing during repeated use. Boaters who swap in this cable report fewer intermittent issues, like erratic up/down signals, which can turn a simple anchoring task into a frustrating ordeal.

Perfect Fit for Your Gen2 Setup

This 22-meter length strikes an ideal balance for mid-sized yachts and sailboats where the control panel might be in the cockpit or nearby helm, far from the bow-mounted windlass. It pairs effortlessly with select Gen2 controls, delivering plug-and-play compatibility that saves hours of wiring headaches.

• Enhanced durability: Multi-strand conductors resist fatigue from vibration and tension.
• Low resistance: Maintains strong voltage for consistent windlass performance, even in wet conditions.
• Flexible routing: Slim profile navigates tight bilge spaces and bulkheads without kinking.

Whether you're retrofitting an older Gen2 system or building a new one, this cable elevates reliability, especially on longer runs where cheaper alternatives falter.

Effortless Installation Tips from Seasoned Skippers

Installing this control cable doesn't require a marine electrician. Start by disconnecting power at the battery to avoid shorts. Route the cable along existing conduit paths, securing it with cable ties every 18-24 inches to prevent chafing against sharp edges. Use heat-shrink connectors for watertight splices if extending slightly.

A pro tip: Test continuity with a multimeter before finalizing connections—check for infinite resistance between wires to catch any nicks. Once connected, cycle the windlass several times in air (no load) to verify smooth operation. Most installs wrap up in under two hours, getting you back on the water faster.

"Switched to this cable after dealing with flaky signals on a 20m run. Night-and-day difference—anchors drop like clockwork now." – Experienced offshore cruiser

Long-Term Maintenance for Peak Performance

To maximize lifespan, inspect the cable annually for frays, corrosion at terminals, or insulation cracks. Rinse with fresh water after every saltwater outing, and apply dielectric grease to plugs for superior moisture sealing. In high-use scenarios like charter fleets, this simple routine extends service life beyond five seasons.

Common pitfalls to avoid: Never coil the cable tightly below 6-inch diameters, as it stresses inner strands. If signals weaken over time, swap it out proactively—better than being caught mid-anchor in a blow.

Real-World Applications Across Vessel Types

From coastal cruisers to bluewater passages, this cable shines in setups demanding distance between controls and windlass. It's a go-to for catamarans with bridgedeck steering stations or monohulls with extended cockpits. Pair it with rope/chain rodes for heavy-duty holding, and you'll appreciate how it handles the torque without hesitation.

For troubleshooting enthusiasts: If your Gen2 windlass chatters or stalls, this cable often resolves ground loop issues better than universal replacements, thanks to its optimized shielding.