Xantrex LinkPro Temperature Kit w/10M Cable

Why Battery Temperature Matters for Accurate Monitoring

Tracking your battery's temperature isn't just a nice-to-have—it's essential for getting the most reliable readings from your battery monitor. Batteries perform differently in hot deserts or chilly nights, affecting capacity, charge rates, and lifespan. The Xantrex LinkPro Temperature Sensor Kit steps in to deliver precise data, ensuring your system adjusts for these swings automatically. Whether you're off-grid in an RV, powering a sailboat, or running a solar setup, this kit helps you avoid undercharging or over-discharging that shortens battery life.

Imagine knowing exactly when your lead-acid or lithium bank is happiest: that's the edge this sensor provides. It integrates seamlessly with your LinkPro monitor, feeding real-time temp info via a sturdy 10-meter cable—long enough for flexible mounting without signal loss.

Key Features That Set It Apart

• M8 Ring Terminal Sensor: Clamps directly onto your battery post for spot-on readings, capturing the core temperature where it counts.
• Extended 10-Meter Cable: Gives you placement freedom, from battery bays in engine compartments to central dashboards.
• RJ12 Connector: Plug-and-play simplicity that snaps right into your LinkPro—no splicing or custom wiring needed.
• Rugged Build: Designed for marine moisture, RV vibrations, and solar exposure, standing up to real-world abuse.

Unlike basic sensors, this one focuses on precision to fine-tune voltage compensation, so your amp-hour counts and state-of-charge percentages stay trustworthy across seasons.

Boost Your LinkPro's Performance

The LinkPro already excels at voltage, current, and SOC tracking, but adding temperature data unlocks its full potential. Cold batteries hold less charge—up to 20-50% less below freezing—while heat accelerates sulfation. This kit tells your monitor to adjust Peukert's exponent and charge efficiency on the fly, mimicking pro-level BMS features without the complexity.

In solar systems, it prevents wasteful overpaneling; on boats, it safeguards against deep-cycle surprises during long anchors. Users report 10-15% better battery utilization after install, extending overall system life.

Simple Installation for Quick Wins

Getting set up takes minutes, not hours. Start by cleaning your battery terminal, slide the M8 ring over the negative post (or positive if specified), and torque to spec. Route the 10m cable away from heat sources or chafe points, then plug the RJ12 into your LinkPro's temp port. Power cycle the monitor, and watch it calibrate—most see accurate temp display immediately.

Pro tip: In multi-bank setups, prioritize the house bank sensor. For lithium, confirm your LinkPro firmware supports it, as temp curves differ from flooded cells.

Ideal for These Setups

• Marine adventures: Anchor confidently with temp-compensated SOC.
• RV living: Handle summer scorchers and winter chills seamlessly.
• Off-grid solar: Maximize harvest by matching charge profiles to real conditions.
• Backup power: Ensure generators kick in only when truly needed.

Frequently Asked Questions