Taylor Made Platinum Series Pontoon Bench Arm Section, Right, White

The Taylor Made Platinum Series right-hand arm section adds a finished, comfortable end to your pontoon bench, and it ships with a built-in cup holder so there's always a spot for your drink within reach. This is the right-side piece, molded and upholstered to match the rest of the Platinum Series furniture. Bolt it into place and it looks like it came with the boat.

If you've ever spent a long afternoon on a pontoon without a proper armrest, you know the difference one makes. Somewhere to rest your elbow while you idle across the lake. A place to set your coffee that isn't the deck. This arm section handles both, and it does it with marine-grade materials made to sit out in the weather season after season.

The frame is rotationally-molded marine grade polyethylene. That matters more than it sounds. Roto-molded PE is one solid piece with no seams to crack, no fasteners working loose from the inside, and it shrugs off UV and moisture in a way wood or particleboard never will. It's the same kind of material used for high-end kayaks and cooler shells. On a pontoon that lives on a lift or a trailer in the sun, that structure is what keeps the seat feeling tight years down the road.

Over the frame you get marine grade vinyl fabric wrapped around mildew resistant polyurethane foam. The vinyl is the part everyone touches, and it's built to take sunscreen, spilled drinks, wet swimsuits, and a garden-hose rinse at the end of the day. The mildew resistant foam underneath is the unsung hero. Pontoon seating traps humidity, and foam that fights back against mildew is what keeps the cushion from turning musty by mid-season.

Everything's held together with stainless steel staples and mounting fasteners, sewn with polyester UV-resistant thread. Stainless is non-negotiable on the water. Plated steel staples rust, bleed streaks down your vinyl, and eventually let go. UV-resistant thread keeps the seams from becoming the first thing to fail, which is usually what happens on cheaper furniture. The stitching outlasting the fabric is exactly what you want.

Dimensions are 8.5 inches long by 25 inches wide by 28 inches tall overall. That 28-inch height is worth measuring against your setup before you order, especially if you run a low bimini or store the boat under a tight cover. It's a full-size arm, not a low stub, so it gives you real support but it does stand up above the seat back.

The built-in cup holder is a small touch that gets used constantly. Anyone who's watched a can slide off a seat cushion on a wake knows why it's there. It keeps a drink upright while you're moving, and it's molded right into the arm so there's nothing to snap off or lose. Little details like that are what separate furniture built for boats from patio chairs someone dropped on a deck.

Who's this for? Anyone building out, refreshing, or repairing a Platinum Series pontoon bench. Maybe a section took a beating and needs replacing. Maybe you're finishing a bench that came without arms. Either way, this is the right-hand piece, so if you're doing both ends you'll want the matching left-hand section too. Matching sides keeps the vinyl aging evenly and the look consistent across the bench.

A word on fit. This is designed for the Platinum Series bench framework, and mounting holes are laid out for that furniture. If you're adapting it to a different bench, measure the mounting pattern first, since holes may not line up without some drilling. When it's going on the furniture it was built for, it's a straightforward bolt-on with the stainless hardware doing the work.

Rinse it with fresh water after salt exposure, wipe the vinyl down now and then, and this arm section will look sharp for a long time. It's a simple piece that does its job and stays out of the way, which is exactly what you want from good pontoon furniture.