Taylor Made Platinum Series Square Corner Lounge Seat, Beige

The Taylor Made Platinum Series square corner lounge seat is a corner module built for pontoons and deck boats where you want real, permanent seating that stands up to the water. It measures 32 inches long by 22 inches wide by 30 inches tall and comes finished in beige marine vinyl. The square corner shape is the piece you drop into an L-shaped bow or stern layout, tying two straight sections together into one continuous lounge.

What sells us on the Platinum Series is the base. Taylor Made rotationally molds the frame from marine grade polyethylene, so there's no plywood in there to soak up water and rot out on you. That's the part that kills cheaper boat furniture. Wood cores swell, delaminate, and turn to mush after a couple of wet seasons. This poly frame just shrugs it off. Hose it down, leave it out in the rain, it doesn't care.

The upholstery is built to the same standard. Marine grade vinyl over mildew-resistant polyurethane foam, stitched with polyester UV-resistant thread. That thread matters more than most people think. Cheap thread is usually the first thing to fail on a boat seat. The stitching rots in the sun long before the vinyl does, and then the seams open up and the foam gets wet. UV-resistant thread holds those seams together season after season. The foam resists the mildew that loves a damp cushion, though like any marine cushion you'll still want to wipe it down and let it breathe when the boat's covered.

Underneath, the seat base is hinged on aluminum hinges, so the cushion flips up and you get at the storage void inside the molded base. Aluminum instead of steel means the hinges won't rust and seize on you. The staples and mounting fasteners are stainless too. Small details, sure, but they're the ones that decide whether a seat still works after five years or turns into a corroded mess.

Fitment is the thing to think through before you order. The 32 by 22 inch footprint drops nicely into corner seating on most 22 to 25 foot pontoons and deck boats. On a narrow 20 foot pontoon it can overhang the deck, so measure your corner before you commit. The seat stands 30 inches tall, standard lounge height, but on a low-profile runabout with a short windshield keep an eye on sight lines from the helm. Because it's a square corner unit, it's designed to sit between two straight lounge sections. Pair it with matching Taylor Made straight seats on the factory mounting pattern and you get a clean, modular L that looks like it came from the builder.

A word on installation. The molded base comes with mounting points, but you're responsible for doing the mount right. On a thin console or deck floor, back up the bolts with a plate or a large fender washer so you don't crack the fiberglass under load. Seal every fastener that goes through the deck with butyl tape or a good marine sealant, because water finds its way into any unsealed hole and rots the floor from underneath. Do that part right and this seat isn't going anywhere.

Be clear on what this is and isn't. It's a fixed corner lounge. It's non-adjustable and non-foldable, and it ships without a headrest, so the back stays at a set recline. That's exactly what you want in a permanent corner module. It's not a captain's chair and it's not trying to be. If you need a reclining or pedestal helm seat, that's a different part. But for building out durable, good-looking lounge seating that survives real marine use, the Platinum Series corner seat is the piece that anchors the whole layout.