Taylor Made 803550 Left Chaise Lounge Boat Seat, Charcoal

If you've ever tried to actually relax on a boat that only came with a couple of bare bench seats, you already know why a proper chaise lounge earns its deck space. The Taylor Made 803550 is the left-hand version of that seat. It gives one person a real place to kick their legs up while everyone else fishes, swims, or just watches the wake roll by. We've rigged plenty of open-deck boats and pontoons where this style of lounge became the seat everybody fought over.

The bones of it are a rotationally molded marine-grade polyethylene frame. That's the same kind of one-piece plastic shell you find in good coolers and kayaks, and it matters here for two reasons. It won't rot, rust, or delaminate the way a wood-cored seat base eventually does, and it shrugs off the constant UV beating that kills cheaper furniture. Over it goes marine-grade vinyl in charcoal, wrapped over mildew-resistant polyurethane foam. The charcoal is a smart pick if your boat sees a lot of sun. It hides scuffs, doesn't show every water spot, and pairs with just about any hull color.

Dimensionally it's a 26 inch length by 17 inch width by 32 inch height seat. That footprint drops in cleanly on most 20 to 25 foot center consoles and pontoons, though on a tighter bowrider you'll want to measure your walkway first so you're not stepping over it every time you move fore and aft. This is the left chaise, so the lounge portion extends to the left as you're sitting in it. If you're building out a matched seating layout, Taylor Made makes the right-hand mirror of this seat so you can run a pair facing each other or flanking a table.

What sells a lot of boaters on this one is the storage. There's a compartment built into the base, which is exactly where you want to stash life jackets, a wet towel, sunscreen, or a tackle bag so it isn't rolling around the cockpit. Two cup holders are molded in as well, so a drink stays put when you catch a wake. It's the kind of small stuff that makes a day on the water feel dialed in instead of cluttered.

The hardware is built for salt and spray. Aluminum seat hinges, stainless steel staples and mounting fasteners, and polyester UV-resistant thread on the seams. Those are the details that decide whether a seat still looks right after three seasons or starts pulling apart at the corners. Stainless staples in particular are a big deal, because plain steel staples are the number one reason budget marine seats get rust streaks bleeding down the vinyl.

A couple of honest install notes from experience. Mount it on flat fiberglass or aluminum deck if you can. If your deck has any curve to it, throw a backing plate or a bit of marine ply under the base so the seat sits flat and doesn't rock. And because that polyethylene shell expands a little in real summer heat, don't crank the mounting bolts down bone-tight against a rigid deck. Leave things just snug. A lot of guys also drill a couple of small weep holes under the base so any water that sneaks in has somewhere to drain instead of sitting under the foam.

This is a non-adjustable, non-foldable seat, and it doesn't come with a headrest. That's by design. It's a fixed lounge meant to be bolted down as permanent seating, not a folding deck chair you stow at the end of the day. If you want something you fold flat and carry off the boat, this isn't it. But if you want a substantial, comfortable, weatherproof lounge that lives on the boat and takes the abuse, the 803550 is exactly that. First-time pontoon owner or a seasoned cruiser refreshing tired old seats, it's an easy upgrade that you'll notice the very first afternoon you actually get to lie back on your own boat.