Taylor Made Platinum Series 36-Inch Pontoon Bench Seat, White

The Taylor Made Platinum Series 36-inch bench seat gives your pontoon or deck boat a full-width perch that's built to live outdoors. It measures 36 inches long, 22 inches deep, and 30 inches tall overall, so it drops into most standard pontoon furniture layouts without eating up your whole deck. The white finish stays cooler under the sun and matches the light, classic look most pontoon owners are after.

What sets this seat apart is the base. The frame is rotationally-molded marine grade polyethylene, the same kind of one-piece plastic used for kayak hulls and cooler bodies. It won't rot, it won't rust, and it shrugs off the splashes, spilled drinks, and wet swimsuits that soak a wood-framed seat over a season. Because the base is molded as a single shell, it also doubles as a dry storage compartment. Lift the seat and you've got room for life jackets, dock lines, a first-aid kit, or a couple of towels.

Taylor Made builds these for real weather, not showroom photos. The cushions wear marine grade vinyl over mildew-resistant polyurethane foam, so a rain shower or a wet bathing suit won't leave you with a moldy, sour-smelling seat by midsummer. The panels are sewn with polyester UV-resistant thread, which is the part cheaper seats skip. Standard thread is usually the first thing to fail on a boat seat, long before the vinyl does. The seams are set with stainless steel staples and the seat swings on aluminum hinges, so the load-bearing and moving parts are all corrosion-minded from the start.

Drainage is handled too. The seat base has molded drainage channels, so water from rain or a hose-down runs out instead of pooling under the cushion. That's a small detail that makes a big difference on a boat that lives on a lift or sits on a trailer uncovered between weekends.

Who's this for? Pontoon and deck boat owners rebuilding tired furniture, or anyone adding a bench to an open deck layout. The 36-inch length seats two adults comfortably and three in a pinch. It's a fixed bench, so keep in mind it's non-adjustable and non-foldable. It doesn't recline, the back doesn't flip for back-to-back seating, and it comes without a headrest. If you want a lounge you can reconfigure, this isn't that seat. What it is, is a solid bench that bolts down and stays put.

Installation is straightforward but worth doing right. On a fiberglass or aluminum deck, through-bolt the base with backing plates or large fender washers underneath rather than trusting self-tapping screws, which can work loose in chop. The legs are a fixed height, so if your deck has any crown or texture, shim under the base with rubber pads before you torque everything down. That keeps the seat from rocking and takes the stress off the mounting points. A dab of dielectric grease at the aluminum contact points is cheap insurance if you run in salt water.

At 36 inches wide it's a genuine bench, so measure your deck before ordering. On boats 20 feet and under it can crowd a walkway, and the 30-inch overall height can block sightlines on a low, open skiff. On a typical 22 to 26 foot pontoon or deck boat, it fits right in. Pair it with a matching Taylor Made polyethylene seat or leaning post if you're building out a full layout and want the mounting hardware and look to stay consistent.

Taylor Made has been building marine furniture, covers, and dock gear for decades, and this Platinum Series bench reflects that. It's not flashy. It's the kind of seat you install once and stop thinking about, which on a boat is exactly what you want.