Taylor Made 34 in. White Side Console Helm Stand, Floor Mount

The Taylor Made 34-inch side console is a floor-mount helm stand built for pontoon and deck boat rebuilds. If you're re-furnishing a pontoon or upgrading a tired factory console, this is the piece that anchors your driving position. It stands 34 inches tall, runs 34 inches long and 26 inches wide, and it's finished in clean white marine vinyl that matches most pontoon furniture sets.

What makes it last is the construction. The frame is rotationally-molded marine grade polyethylene, so it's one solid molded shell instead of a bunch of welded joints that can crack or loosen. That matters on the water, where a helm stand takes a beating from vibration, sun, and the occasional hard landing off a wake. The cushions use mildew-resistant polyurethane foam wrapped in marine grade vinyl, stitched with polyester UV-resistant thread that won't rot out after a couple of seasons in the sun.

The seat hinges are aluminum and the whole thing is put together with stainless steel staples and mounting fasteners. That's the right hardware for a marine build. Regular steel staples rust and bleed streaks down your vinyl within a season, so it's good to see stainless here from the factory.

Installation is straightforward if you plan it. The base bolts down to the deck through the floor. On a pontoon with a plywood deck, drop backing plates or large fender washers under the deck at each bolt so the fasteners don't work loose or pull through when you're running in chop. Don't just screw it down. Through-bolt it. A helm stand carries the driver's weight plus everything you lean on it for, and you want that load spread across the deck, not hanging on four screws.

This is a side console, meaning it mounts to one side of the deck with the helm facing forward. It gives you a clean spot for your wheel, throttle, gauges, and a switch panel, with the seat built right in. On boats under about 20 feet of beam, measure your walkway before you buy. A 26-inch-wide base can tighten up the side aisle on a narrow deck, so make sure you've still got a comfortable path fore and aft.

Who's this for? Pontoon owners doing a full furniture swap, folks restoring an older deck boat, and anyone who wants a matched white helm stand instead of piecing together a mismatched console and seat. It's not a bolt-in replacement for a specific OEM console, so treat it as a universal helm stand and plan your rigging, wiring runs, and steering mount around it.

A few tips from the rigging bench. Run a bead of marine seam sealer where the vinyl meets the aluminum hinges at install. That's the first spot to show wear, and a little sealer up front keeps water out of the seam. And if this boat lives in saltwater, rinse the base and hardware after every trip. The stainless holds up well, but salt is patient.

On the comfort side, the foam has enough density to hold up under a full-size adult without bottoming out, and the seat height puts you at a natural reach to the wheel and throttle. Pair it with a matched companion seat across the deck and you've got a helm layout that looks and feels like it came that way from the builder.

Taylor Made has been building marine furniture, tops, and covers for decades, and the vinyl work shows it. The marine grade vinyl is treated to shrug off UV, mildew, and the general abuse of an open deck. Wipe it down with mild soap and water, keep a cover on it when the boat's parked, and the white stays white instead of going yellow and chalky.

Color-wise this is the white version. Taylor Made runs this same helm stand in other shades across the Platinum Series, so if you're matching an existing furniture set, check the rest of your seats before you commit to white. Getting the helm stand to match the loungers and bench seats is what makes a rebuild look factory instead of pieced together.