Sea-Dog Chrome Brass Lift Handle 222340-1
Sea-Dog Chrome Brass Lift Handle 222340-1 — Product description
The Sea-Dog chrome plated brass lift handle gives you a solid, corrosion-resistant grip for hatches, floor lockers, and deck plates. Solid brass under a bright chrome finish, with a 4-1/16 inch mounting hole center for a clean two-fastener install.
The Sea-Dog chrome plated brass lift handle is one of those small pieces of deck hardware you don't think about until you need one. It gives you a solid grip to lift a hatch, a floor locker, or a deck plate, and the chrome over solid brass holds up to salt spray and sun far better than a thin stamped part.
Mounting is straightforward. The hole centers sit 4-1/16 inches apart, so you drill two holes, drop in your fasteners, and you're done. It sits low and out of the way, which keeps it clear of bare feet and dock lines. We see these used on live wells, in-deck storage, engine hatches, and cabin sole panels.
Brass is the right material here. It won't rust, and the chrome finish keeps it looking sharp season after season. If you're replacing a corroded pull or rigging out a new hatch, it's a clean, no-nonsense choice that'll outlast the boat around it.
Key Features
- Solid chrome plated brass construction resists salt spray, rust, and UV fading
- 4-1/16 inch mounting hole center for a straightforward two-fastener install
- Low-profile lift design keeps it clear of bare feet, dock lines, and gear
- Fits hatches, floor lockers, deck plates, live wells, and cabin sole panels
Why Buy from NVN Marine
- Authorized Sea-Dog reseller, full manufacturer warranty
- NMEA member and ABYC certified, advice from real boat techs
- Same-day shipping before 3 PM ET on in-stock items
- NY headquarters and Fort Lauderdale flagship retail store
Technical specifications
| Title | Chrome Plated Brass Lift Handle |
|---|---|
| Brand | Sea-Dog |
| Manufacturer Part Number | 222340-1 |
| UPC | 035514222068 |
| Material | Chrome Plated Brass |
| Mounting Hole Center | 4-1/16 Inch |
| Product Type | Lift Handle |
Frequently asked questions
What is this lift handle made of?
It's solid brass with a chrome plating. Brass won't rust, and the chrome finish adds a hard, bright surface that stands up to salt spray and sun.
What is the mounting hole spacing?
The mounting hole centers sit 4-1/16 inches apart. You drill two holes at that spacing and fasten it down.
Where can I use this handle on my boat?
Anywhere you need to lift a panel by hand. We see them on hatches, in-deck storage lockers, deck plates, live wells, engine covers, and cabin sole panels.
Will it hold up in salt water?
Yes. The combination of solid brass and chrome plating handles a saltwater environment well and resists the corrosion that eats up cheaper stamped hardware.
