RAILBLAZA Kayak Motor Mount Bracket for Trolling Motors

If you fish from a kayak and you've been eyeing a small electric to save your arms on the long paddle back, this is the piece that ties it all together. The RAILBLAZA Kayak Motor Mount Bracket is a complete kit for hanging a trolling motor off the stern of just about any kayak. It's 46-1/2 inches of black and silver bracket that fits all model kayaks and works with both transom-mount and clamp-on trolling motors. So whatever small motor you've got, or you're planning to buy, this bracket gives it a home.

What we like is that it's a full kit, not just a bar and a promise. You get the motor mount bracket itself, two rail mounts, two male-to-male adaptors, and two sets of StarPort HD stainless steel hardware. That's everything you need to get mounted on most sit-on-top hulls without a run to the hardware store halfway through the job. The StarPort HD bases are the same mounting standard RAILBLAZA uses across their accessory line, so once these are on your deck you can swap in rod holders, camera arms, and other gear on the same footprint.

A word on the install, because a motor mount lives or dies on how well it's bolted down. Any time you drill into a kayak hull, bed the hardware in a good marine sealant before you snug it up. Kayak decks flex and sit right at the waterline, and an unsealed hole will find a way to let water into the hull. Take the extra ten minutes. On the male-to-male adaptors, a drop of threadlocker keeps them from backing out after a few outings of vibration. That's a small habit that saves you fishing a loose adaptor out of the bilge later.

The 46-1/2 inch length gives you real reach past the stern, which keeps the prop clear of the hull and out of your paddle stroke. Keep the motor size sensible, though. A high-thrust motor on choppy water will flex the pole more than you'd like, and that flex telegraphs right back through the mount. For most kayak anglers a lower-thrust motor is the sweet spot. It pushes a loaded fishing kayak at a comfortable troll all day, and it won't overwork the bracket. If you run bigger water, plan your speed around the conditions rather than the motor's top end.

Fitment is flexible but not automatic. The rail mounts adapt to most sit-on-top rail and gunwale layouts, and on some hulls you'll want a thin shim to bring everything flush and solid. If you're going the clamp-on route on a rounded gunwale, a strip of rubber under the clamp stops it from creeping under load. None of this is hard. It's the kind of small fitting work every kayak rig needs, and the payoff is a motor that stays put when you're leaning into a fish.

Corrosion is the other thing to stay ahead of. The included hardware is stainless, and it holds up fine in freshwater. If you fish brackish marsh or the salt, give the whole assembly a fresh-water rinse when you're done for the day. Stainless is tough, but salt sitting in the threads will pit it over time. A quick hose-down keeps the hardware turning smooth season after season.

Bottom line, this is a straightforward, honest piece of kit for the kayak angler who wants to cover more water without wearing out. It suits solo and tandem hulls alike. Just remember it's the mount, not the motor, so you'll supply your own trolling motor to match. Rig it right, seal your holes, keep the thrust reasonable, and you've got a clean, repeatable way to run power on your kayak.