Marinco 200BBI Bass Boat Power Inlet 20A 125V Front Mount

The Marinco 200BBI.OEM is a front-mount power inlet built for bass boats and other small craft that carry an onboard battery charger. It gives you a clean, permanent place to plug in shore power so you can top off your trolling motor and cranking batteries overnight without running an extension cord through a hatch or over the gunwale. Rated at 20 amps and 125 volts AC, it handles the standard household-style shore connection most bass boats rely on.

Here's the basic idea. Your boat's charger stays wired to the batteries. The 200BBI mounts through the hull or a console panel and connects to that charger on the inside. When you're back at the dock or in the driveway, you run a cord from a wall outlet to the inlet, and the charger does the rest. No lifting seats, no propping open compartments, no cord pinched in a lid all night. It's the difference between a tidy, marine-grade connection and a temporary rig you have to redo every trip.

Marinco built this one to live outside. The housing is UV-resistant nylon, so it won't get chalky and brittle after a couple of seasons in the sun the way cheaper plastic does. The terminals use Marinco's Perma-Lock brass design for a solid, corrosion-resistant electrical connection, which matters a lot when you're dealing with salt air, spray, and the constant vibration of a boat on the trailer. A UV-resistant molded flexible vinyl cover seals over the face when the inlet isn't in use, and a dust cover is included to keep grit and moisture out of the contacts between trips.

The front-mount design keeps installation straightforward. You cut the mounting hole, drop the inlet in from the front of the panel, and secure it. The body measures 2.5 inches in diameter and sits 2.67 inches deep behind the panel, so check your clearance before you commit to a spot, especially in a tight console or a thin bulkhead where wiring and other gear compete for room. The black finish blends into most bass boat consoles and dark hull sides without drawing attention.

Because it carries UL and CSA approval, you know the 200BBI has been tested to recognized North American safety standards for this kind of AC connection. That's not a small thing on a boat. Shore power and water don't mix well, and a properly rated, properly installed inlet is your first line of defense against a bad connection. If you're wiring this into a boat, follow ABYC practices, use marine-grade wire on the charger side, and make sure your charger and breaker match the 20-amp, 125-volt rating.

Who's this for? Bass boat owners, mostly. Anyone running a two- or three-bank onboard charger who's tired of fishing an extension cord into a battery compartment. It's also a smart upgrade if your old inlet has gone yellow and cracked from UV exposure, or if you're rigging a new boat and want the charging connection done right from day one. The OEM designation means this is the same style of inlet boat builders spec from the factory, so it'll look and function like a factory-installed part.

A couple of honest notes. This is the inlet only. It doesn't come with a shore power cord or the onboard charger, so you'll pair it with the cord and charger that fit your setup. And it's a 20-amp, 125-volt AC part, which covers the vast majority of bass boat charging needs but isn't meant for the high-draw 30-amp systems you'd find on larger cruisers. For a bass boat or small fishing rig, though, it's exactly the right size.

Little details make a part like this worth buying once. The flexible vinyl cover flips out of the way when you plug in and snaps back when you're done, so it's always there when you need it instead of dangling by a broken tab. The brass terminals take a familiar connection on the back, keeping the wiring simple for anyone who's rigged a boat before. And the whole assembly is compact enough to tuck into the corner of a console or a side panel where it stays out of the way of your feet and your gear.