Lumishore Eclipse SL100 White Strip Light, 2.5m

The Lumishore Eclipse SL100 white strip light gives you clean, usable light exactly where a fixed fixture can't go. At 2.5 meters long, this single-color white strip tucks into gunwales, under seating, behind ceiling panels, and along toe rails, spreading a soft, indirect glow while the strip itself stays mostly hidden. It's the finishing touch that makes a boat feel properly built rather than just equipped.

The white here is a crisp 5000K, a daylight-neutral tone that reads clean and makes colors look true. That makes this strip genuinely useful, not just decorative. Run it under the gunwales to light the cockpit sole so nobody trips at night, tuck it beneath a galley overhang for practical work light, or set it behind a panel to wash a bulkhead with an even glow. It carries 60 white LEDs per meter for a continuous line of light with no obvious gaps or hot spots.

Lumishore builds these strips for the marine environment rather than merely surviving it. The whole strip is fully encapsulated and potted, then sealed to an IP68 rating, the highest ingress protection in the Eclipse lineup. That's what lets it live in the wet, exposed places where accent lighting actually belongs, shrugging off spray, wash-down, and damp without fogging or corroding. An ordinary indoor LED strip wouldn't last a season out here. This one is made to.

Installation is flexible by design. The SL100 is a plug-and-play strip that you cut to length for your run, then seal the cut end before mounting. The electrical side is a simple two-wire hookup, and you can drive it from a basic on/off switch or wire it into the Lumishore ECLIPSE Command Center for centralized control. Its slim cross-section of 10.8mm x 5.2mm (0.425 in x 0.204 in) slips into channels and reveals that a bulkier strip could never fit.

Power is easy to plan around. The strip runs on a 12V DC supply within a 10 to 15V range and draws about 0.5A per meter (6W per meter), so a full 2.5m run pulls a modest, predictable load from the house bank. Because you know the draw per meter, sizing wire and fusing for a longer install with several strips is straightforward.

If you've never added accent lighting to a boat, the difference is bigger than you'd expect. Indirect white light makes a cockpit feel larger and more welcoming after dark, and it makes moving around safer because you can see steps, edges, and cleats without a harsh overhead glare in your eyes. It's the kind of upgrade you appreciate every evening you're aboard, and it's backed by a 3-year warranty. Since it's part of the SL100 platform, you can pair this white strip with blue or dual-color runs elsewhere and keep the whole boat looking like one coordinated system.

Here's how we'd use it. Run a strip under the gunwales and beneath the helm seat, wire it to a switch you can reach easily, and use it for boarding, cleanup, and any task that needs honest light after dark. Because you cut it to length, it fits your boat exactly instead of forcing you to work around a fixed size, and the sealed, potted build means you install it once and forget about it.

What makes white such a versatile choice is that it does double duty. It's bright and true enough to work by, so it earns its place in the galley, the heads, and along the steps, and it still looks clean and finished as pure accent light washing a bulkhead or a locker interior. If you're lighting the practical, hard-working parts of the boat, white is usually the right call. And with the strip fully potted and sealed to IP68, you can run it in the wettest, most exposed spots and count on it holding up through spray, wash-down, and season after season on the water.