Egis 4706-001 Panel-Mount Breaker Trim Bezel, Black

The Egis Mobile Electric 4706-001 is the molded rubber trim bezel that finishes off a panel-mount circuit breaker install. It's a small part, but it's the one that makes the difference between a breaker that looks like it came with the boat and one that looks like it got added in the driveway. If you've ever cut a hole in a dash for a 285 Series or 4706 panel-mount breaker and ended up staring at a raw edge around the breaker body, this is the piece you were missing.

Here's what it does. The bezel is flexible molded rubber that wraps the breaker where it passes through the panel. It's self-trimming, which means it conforms to the thickness of your panel instead of needing a specific depth to seat right. Thin fiberglass dash? Thicker composite panel? Same bezel, and it settles in clean either way. The rubber flexes as you push it home, so you get a snug collar around the breaker with no gap for the eye to catch or for spray to sneak behind.

That spray point matters more than people think. A helm takes weather. Rain, wash-down, the odd wave over the bow, condensation under a console. A bare panel cutout around a breaker is an open invitation for water to track down behind the dash and find the terminals. The rubber bezel gives you a flexible seal at the panel face that sheds water away from the opening and keeps the install looking tidy for years, not months.

Compatibility is straightforward. The 4706-001 is built for the Egis Mobile Electric 85 Series, 285 Series, and 4706 Series panel-mount circuit breakers, covering the 25 amp through 150 amp range. If you're running one of those breakers for a windlass, a thruster, an inverter feed, or any high-draw DC load, this is the matching bezel. Because it's keyed to the Egis panel-mount family, the fit is dialed in, not a universal grommet you have to fight.

A couple of honest notes so you order right. This is the bezel only, sold as a single. It is not the circuit breaker itself, and it doesn't ship with one. If you're wiring up a fresh panel, you'll want one bezel for each panel-mount breaker you're finishing. And because it's molded rubber, installation is tool-free. You seat the breaker in the panel, then work the bezel over the front so the lip sits flat against the dash. No adhesive, no fasteners, no fuss.

One more fitment tip. Because the bezel is matched to the Egis panel-mount family, it lines up with the breaker's mounting footprint instead of leaving you to shim or trim a generic ring. Dry-fit the breaker and bezel together before you commit to the cutout, mark your hole, and you'll get a flush, factory-looking result the first time.

The black finish is a deliberate choice. It disappears against most dark dash panels and switch clusters, so the breaker reads as part of the layout instead of a bolt-on. And molded rubber holds up out there. It won't corrode like a metal ring, it stays flexible in the cold, and it takes UV and salt air without getting brittle and cracking the way cheap plastic trim does. For a part that lives at the helm and gets touched every time you flip a breaker, that durability earns its keep.

Who's this for? Anybody doing a clean DC panel build or a repair where the old trim ring is torn or missing. Riggers finishing a console, owners upgrading a breaker panel, techs who want the job to look right. It's an inexpensive part, but skipping it is the kind of shortcut you notice every time you sit at the helm. Order the bezel, finish the hole, and move on to the next wire.