Egis A Series White Toggle Breaker 3201-03, 2.5A Single Pole
Egis A Series White Toggle Breaker 3201-03, 2.5A Single Pole — Product description
The Egis A Series 3201-03 is a white toggle panel mount circuit breaker rated for 2.5 amps, single pole, AC and DC. It's the right-sized protection for small boat circuits, with a manual toggle and mounting screws included.
The Egis A Series White Toggle Panel Mount Circuit Breaker, model 3201-03, is a single pole breaker rated for 2.5 amps. That's a small number on purpose. This is the breaker you reach for when a circuit only needs a couple of amps and you want protection sized to match, not a big breaker that lets a wiring fault run hot before it trips.
It's a magnetic-hydraulic design, and it's rated for both AC and DC. You get 277 Vac and 80 Vdc maximum voltage, so the same part can sit on a 12 or 24 volt DC panel or on an AC branch circuit. The toggle gives you a clear on and off position at the panel, which means you can kill a circuit by hand for service without pulling a fuse or disconnecting a wire. When it trips, you flip it back. No hunting for a spare in the glove box.
Think about where 2.5 amps actually shows up on a boat. Small electronics, a gauge or instrument feed, a bilge alarm, a stereo remote lead, a small accessory that sips power. These loads are small, and the wire feeding them is usually small too. Small wire needs small protection. A breaker with the right amp rating trips before the insulation gets hot, and that's the whole job. Egis describes it as protecting circuits from short circuit events and over-current loads, preventing wire insulation overheating and the damage that follows.
Interrupt capacity matters more than most people think. Boats with big paralleled battery banks can push a lot of current into a dead short. This breaker is rated for 5kA at 277 Vac and 1.5kA at 80 Vdc, so it's built to open safely on circuits connected to large battery banks with significant available power. That's a good spec to see on a part this small.
Mounting is straightforward. It fits standard panels that accept A Series and C Series magnetic-hydraulic breakers, so if you're swapping one into an existing Egis panel, the cutout should already be there. The mounting screws are included, and they're stainless steel self locking hardware. Self locking matters on a boat because vibration backs ordinary hardware off over a season, and a loose connection on a breaker is a heat problem waiting to happen. Snug it down, check it again after the first few trips out, and you're set.
The breaker carries UL 1077 regulatory compliance, and Egis rates the electrical endurance at 6,000 cycles at rated current. That's a lot of flips for a switch you'll mostly leave alone. Egis backs it with a 4 year warranty. It ships in a retail pack, so you get it clean and ready to install.
A few honest notes before you order. This is a 2.5 amp breaker, so check your actual load before you pick it. If the circuit draws close to 2.5 amps continuously, step up to the next size and make sure your wire gauge matches the breaker you choose. Breaker size follows the wire, not the other way around. Egis sells this A Series toggle in a range of other amp ratings, so if 2.5 isn't right for your circuit, there's likely a sibling that is. And if you're not sure how to size a circuit or you're building a new panel, give our crew a call. We'd rather help you get it right than sell you the wrong part.
Egis Mobile Electric has been building electrical protection gear for over 25 years, with products aimed at marine applications, fleet vehicles, and other specialty vehicles. This breaker comes from that same line of safe, dependable battery protection technology. For a clean white toggle at the panel and a breaker that matches a small circuit, it's a sensible, no-nonsense part.
Key Features
- 2.5 amp continuous current rating sized for small circuits like gauges, alarms, and low-draw accessories
- AC and DC rated with a 277 Vac / 80 Vdc maximum voltage, so it works on both DC and AC panels
- Magnetic-hydraulic design protects against short circuits and over-current loads, preventing wire insulation overheating
- High interrupt capacity of 5kA at 277 Vac and 1.5kA at 80 Vdc for circuits tied to large paralleled battery banks
- Fits standard panels that accept A Series and C Series magnetic-hydraulic breakers
- Stainless steel self locking hardware keeps connections tight through vibration
- Mounting screws included, so you can install it right out of the pack
- UL 1077 recognized with 6,000 cycles of electrical endurance at rated current
- Clear white toggle gives you a hand reset and a manual on/off at the panel
- Backed by a 4 year Egis warranty
Why Buy from NVN Marine
- Authorized Egis Mobile Electric reseller, full manufacturer warranty
- NMEA member and ABYC certified, advice from real boat techs
- Same-day shipping before 3 PM ET on in-stock items
- NY headquarters and Fort Lauderdale flagship retail store
Technical specifications
| Title | Egis A Series White Toggle Panel Mount Circuit Breaker - Single Pole 2.5A |
|---|---|
| Brand | Egis Mobile Electric |
| Manufacturer Part Number | 3201-03 |
| UPC | 850074331117 |
| Series | A Series |
| Color | White |
| Style | Toggle Panel Mount |
| Poles | Single Pole |
| Continuous Current | 2.5 Amps |
| Rated Current Type | AC and DC |
| Max Voltage | 277 Vac / 80 Vdc |
| Interrupt Capacity | 5kA / 277Vac, 1.5kA / 80 Vdc |
| Electrical Endurance at Rated Current | 6,000 Cycles |
| Regulatory Compliance | UL 1077 |
| Hardware | Stainless Steel Self Locking |
| Mounting Screws | Included |
| Warranty | 4 Years |
| Packaging | Retail Pack |
Frequently asked questions
What amp rating is the Egis 3201-03 breaker?
It's rated for 2.5 amps continuous current. It's a single pole breaker, so it protects one hot conductor.
Is this breaker AC or DC rated?
Both. Egis rates it for a maximum of 277 Vac and 80 Vdc, so it can be used on DC circuits and on AC circuits within those limits.
What type of breaker is it?
It's a magnetic-hydraulic toggle breaker that mounts in a panel. It protects against short circuit events and over-current loads.
What is the interrupt capacity?
Egis lists 5kA at 277 Vac and 1.5kA at 80 Vdc. That lets it safely protect circuits connected to large paralleled battery banks.
Does it come with mounting hardware?
Yes. Egis includes mounting screws, and the hardware is stainless steel self locking.
Will it fit my existing panel?
It mounts in standard panels that accept A Series and C Series magnetic-hydraulic circuit breakers. Check your panel's cutout and series before ordering if you're unsure.
What certification does it carry?
Egis lists UL 1077 as the regulatory compliance standard for this breaker.
How many cycles is it rated for?
Electrical endurance at rated current is 6,000 cycles.
What warranty does it have?
Egis covers it with a 4 year warranty.
How do I choose the right amp rating?
Match the breaker to the wire gauge on the circuit, then make sure the breaker's rating sits above your normal load. If your load runs close to 2.5 amps continuously, step up to the next size and confirm the wire can handle it. If you're not sure, call our crew.