Dometic 9100 Awning Fabric Roller Tube 17 ft, Onyx Fade

A worn or torn awning fabric doesn't mean you need a whole new awning. This Dometic part is the fix. It's a replacement fabric roller tube assembly for the 9100 Series patio awning, and it arrives with fresh 17 ft Onyx Fade vinyl already rolled onto the tube. You reuse your existing motor and arms, swap in the new roller, and your awning looks and works like new again.

It's important to be clear about what this is and isn't. This is a replacement part, not a complete awning. It does not include the electric motor, the drive assembly, or the support arms, because those parts stay with your rig. What you're buying is the fabric and the roller tube it's wound on, matched to fit the Dometic 9100 Series. If your awning hardware is sound but the fabric has faded, cracked, stretched, or torn, this is exactly the component you want.

The fabric itself is Onyx Fade, a black vinyl with a graduated fade pattern that reads clean and modern against most coach finishes. Vinyl is the right material for a job like this. It sheds rain instead of soaking it up, and it resists the sun damage and mildew that eventually wear out any awning that lives outdoors. Choosing a genuine 9100 roller tube assembly also means the fabric width, the roller diameter, and the end fittings all match your existing awning, so the new fabric tensions correctly and rolls up cleanly on the first try.

Replacing the roller tube is a well-understood job for anyone comfortable working on their awning. With the awning retracted and the spring tension safely released, you unfasten the old roller from the arms, slide the new assembly into place, and re-tension the spring per Dometic's instructions. The fabric is already wound and aligned on the tube, which takes the hardest part, getting the fabric straight and taut, off your plate. That said, awning springs hold real tension, so if you haven't done this before it's worth reading the procedure carefully or having an experienced installer handle it.

At roughly 17 ft of fabric, this roller fits the larger patio awnings in the 9100 lineup. Double-check your current fabric length before ordering so the new roller matches your arms and rail spacing. Getting the length right is the one measurement that matters most, since the roller has to span exactly between your existing arm mounts.

Dometic backs the assembly with a limited one-year warranty, and because it's a genuine 9100 part you can trust the fit and the material quality. The complete roller and fabric assembly weighs around 59.5 pounds, which reflects the full-length aluminum tube inside, the part that keeps the fabric flat and the tension even across the whole span.

It's worth thinking about timing, too. Awning fabric rarely fails all at once. It starts with a little fading, then some brittleness at the edges, then a small tear that grows every time the wind catches it. Catching that early and swapping in a fresh roller assembly is far cheaper and far less stressful than dealing with a fabric that lets go mid-trip and leaves you scrambling. Because the new fabric comes pre-wound and matched to the 9100 hardware, a planned replacement at home is a calm afternoon project rather than a roadside emergency. Keeping a sound awning over your patio also protects your chairs, your gear, and your comfort from sun and sudden showers.

If your 9100 awning still extends and retracts fine but the fabric has seen better days, this is the smart, economical repair. You keep the hardware you already trust, you skip the cost and labor of a full awning replacement, and you get back to enjoying shade that looks sharp again. It's a straightforward way to add years to an awning you've already got.