Dometic DM2852 Series Refrigerator Upper Freezer Door (2932561307)

If the upper door on your Dometic DM2852 refrigerator is cracked, delaminated, or just won't seal the way it used to, this is the replacement you're after. It's the upper door for the DM2852 series, the freezer door that sits above the fresh food compartment, and it carries Dometic part number 2932561307.

Doors take a beating in an RV or a boat galley. They get slammed on rough roads and choppy water, the panel skins peel at the edges after enough seasons in the sun, and a warped door is the fastest way to lose cold air and run your cooling unit ragged. Swapping the whole door is usually cleaner than trying to patch a tired one. You get a fresh seal surface, straight edges, and a latch that actually holds.

This one is a direct Dometic replacement, so it's built to the same fit as the door that left the factory on your DM2852. That matters. A refrigerator door isn't a place to guess on dimensions or hinge geometry. Get the right door and it lines up with your existing hinges and closes flush. Get the wrong one and you're fighting gaps and gasket squish for the life of the fridge.

Here's the one thing to check before you order. The DM2852 was built in more than one configuration over its run, and doors come in an upper and a lower, plus left-hand and right-hand orientations depending on how your fridge is set up. This part is the upper door for the DM2852 series. Pull the model and configuration off the data plate inside your refrigerator, confirm you need the upper door, and confirm the hinge side matches your cabinet. Two minutes with the data plate saves you a return.

Who's this for? RV owners running a DM2852 two-door absorption fridge, and boaters with the same unit in the galley. If you've had the rig a while and the freezer door looks rough, or a previous owner left you with a beat-up door, this brings the front of your fridge back to right. It's a straightforward swap for anyone comfortable with a screwdriver and a little patience.

A quick word on what this is and isn't. This is the door itself. It's not the lower fresh food door, it's not the cooling unit or the control board, and it's not the door bins and shelves. If your bins are cracked or missing, those are separate Dometic parts. And if it's the lower door that's damaged, you'll want that part number instead. When in doubt, match the number on your old door to the number here.

Installation is honest work. You'll transfer your hinges, get the door hung and squared, and check that the gasket seats evenly all the way around before you call it done. Take your time on the gasket. A door that seals clean keeps your box cold and takes the load off the cooling unit, which is what you want for a long, quiet life out of an absorption fridge.

One more tip from the dock. Before you pull the old door, take a photo of the hinge stack and the order of any washers and spacers. Absorption fridge doors ride on simple hardware, but getting the spacer order right on reassembly is what keeps the door from sagging over time. Reuse good hardware, replace anything worn, and snug everything down evenly. Do that and the new door hangs true from day one.

The simplest way to order with confidence is to match the number. Find the part number stamped on your old upper door or listed on the refrigerator data plate, and check it against 2932561307. If it matches, you're ordering the right door. If you're between the upper and the lower, remember the upper is the freezer door up top and the lower is the fresh food door beneath it. A quick look before you buy keeps this a one-and-done job instead of a back-and-forth.