Carver 77522P-10 Poly-Guard Pontoon Boat Cover, 22'6" Haze Gray

The Carver 77522P-10 is built for one job and does it well: keeping a 22 foot 6 inch pontoon protected through the off-season and every stretch of downtime in between. It's a styled-to-fit storage cover shaped for pontoons that run a bimini top and full-height rails all the way around the deck, so it drops over the whole boat and closes it up top to bottom. If that's your layout, this is the cut that actually fits.

Fit is where most pontoon covers go wrong, and it's worth getting right. This one is sized for a center line length of 22 feet 6 inches with a beam width up to 102 inches. Measure your boat bow to stern along the deck, then check your widest point across the rails. If you land inside those numbers, you're good. Go too small and you'll fight to get it on. Too big and it flaps in the wind, which is exactly what wears a cover out.

The fabric is Carver's Performance Poly-Guard, a marine-grade polyester in haze gray. It's water repellent, so rain and snowmelt bead up and run off instead of soaking through. It's treated for UV, which matters more than people think. The sun is what quietly kills a cover and fades a deck over a few seasons. And it's mildew resistant, so the boat isn't sitting under a damp, musty tarp come spring. Haze gray is an easy color to live with. It hides dust and doesn't show every water spot.

Carver includes heavy-duty tie-down straps with this cover, and you'll want to use all of them. A pontoon is a big flat sail when the wind picks up. Snug straps under the deck and around the pontoons keep the cover from lifting, ballooning, or working loose overnight. We tell folks to walk the boat after the first big blow and re-snug anything that's gone slack. Ten minutes then saves you a torn cover later.

A couple of real-world tips from the yard. First, ventilation. A cover this tight can trap condensation underneath if the boat's shut up completely. Leave a small gap or prop a support under the fabric so air can move and moisture doesn't collect on your seats and console. Second, support the top. The rails carry most of the load, but a low spot invites water to pool, and pooled water is heavy. A single center support pole or a pool noodle over a high point sheds it and takes the strain off the seams.

This is a storage cover, not a travel cover. It's made to protect the boat on the trailer in the driveway, in the yard, or under a lean-to during the off-season. It isn't cut or rated for trailering down the highway at speed, where wind gets under the fabric and turns it into a problem. If you need to tow covered, that's a different product, and we're happy to point you to the right one.

Carver has been sewing covers and tops for over 30 years, and they build this line right here in the USA. That shows up in the details that matter on a cover you'll pull on and off for years: the seams, the strap anchor points, and a cut that's shaped to the boat instead of thrown over it. Every package also includes a separate outboard motor cover, so your engine gets buttoned up along with the deck.

If you've got a 22 foot 6 inch pontoon with a bimini and full rails, and you want it covered right through the winter, the 77522P-10 is a straightforward, honest choice. Get the measurements right, use every strap, give it a little airflow, and it'll pay you back season after season.