Camco PowerGrip 55191 30-Amp 25-ft RV Power Cord

The Camco PowerGrip 55191 is the 30-amp power cord that connects your RV to the pedestal, and it's built to take the daily abuse that job hands out. You get 25 feet of heavy 10-gauge STW cable with a standard NEMA TT-30P plug on one end and a matching TT-30R receptacle on the other. That's the everyday cord for travel trailers, fifth wheels, truck campers, and toy haulers that run on a single 30-amp service. Plug the male end into the campground pedestal, run the female end to your rig's inlet, and you're powered up.

Here's what makes the daily grind easier. Both ends carry Camco's molded PowerGrip handles. Anyone who's tried to yank a stiff cord out of a tight pedestal socket in the rain knows how much that grip matters. You pull on the handle, not the wire, which keeps strain off the prongs and the cable jacket where cords usually fail first. It's a small thing until it's 9 PM, it's pouring, and you're trying to break camp.

The cable itself is 10-gauge, three-conductor STW. That gauge is what lets it carry a full 30-amp load, roughly 125 volts and 3,750 watts, without the voltage sag that cooks air conditioners and starves converters. Run your rooftop AC, the microwave, and the water heater at the same time and this cord won't be the weak link. The STW jacket handles sun, weather, and getting dragged across gravel, though like any heavy copper cord it does stiffen up when the temperature drops below 40 degrees, so plan on a little more muscle coiling it on a cold morning.

A carrying strap comes attached, which sounds minor and isn't. Twenty-five feet of 10-gauge copper is heavy and wants to tangle. The strap lets you loop the coil, sling it, and toss it in the storage bay without it turning into a bird's nest by the next stop. Wrap it the way it wants to lay and it'll behave.

Worth knowing what this cord is and isn't. It's a direct 30-amp connection or extension, TT-30P to TT-30R, nothing more clever than that. There's no built-in surge protection and no GFCI in the cord, so if you camp at older parks with questionable wiring, run a dedicated 30-amp surge protector at the pedestal ahead of it. The cord moves power. The protector guards your rig. Those are two separate jobs and you want both. Camco also lists the 55191 as a Level 1 EV charging cord, so if you run one at the site, the TT-30P end matches many Level 1 setups.

Length is the other honest note. Twenty-five feet covers the great majority of pull-through and back-in sites with the pedestal a reasonable distance off your inlet. If you routinely land in spots where the power post sits way back, keep a matching 30-amp extension in the bay so you're not stretching this one tight. A cord under tension pulls on both connectors and that's how you crack a plug.

Storage is where cords live or die, and this one's easy to keep alive. After each trip, coil it loose, keep the connector ends up off the storage bay floor so they don't sit in road spray, and give the TT-30R contacts a light shot of dielectric grease once a season if you camp near salt air or damp coastal sites. Contacts stay clean, the connection stays cool, and a cool connection is a safe connection. Do that and a cord like this lasts years, not seasons.

Bottom line, this is the no-drama 30-amp cord to keep in the bay. ETL listed, heavy 10-gauge copper, grip handles on both ends, and a strap that actually earns its keep. It's the one you reach for at every stop and forget about, which is exactly what you want from shore power gear.