Camco 40161 14-Inch RV Roof Vent Lid | Ventline/Elixir

If the vent lid on your RV blew off on the highway or finally cracked after too many summers in the sun, this is the fix. The Camco 40161 is a direct replacement lid for 14 inch by 14 inch roof vents, built to fit Ventline units manufactured before 2008 and Elixir units manufactured from 1995 on. It's the white one, molded from polycarbonate so it won't shatter the way an old brittle lid does. The lid and the mounting hardware both come in the box, pre-assembled and ready to go up on the roof.

Here's the thing about RV vent lids. They take a beating. Sun, heat, freezing nights, the odd tree branch at a tight campsite, and highway wind every single time you tow. The original acrylic or thin-plastic lids go chalky and brittle after a few seasons. Then one day a gust catches a cracked corner and the whole thing is gone down the interstate behind you. This polycarbonate lid is made to outlast that. It flexes instead of cracking, and it stands up to UV a lot better than the piece it's replacing. That's why Camco calls it unbreakable.

Fitment is the one thing to nail down before you order. This lid fits Ventline vents manufactured prior to 2008 and Elixir vents manufactured 1995 and on. That covers a huge slice of travel trailers, fifth wheels, and motorhomes from those years. The two brands used the same hinge and mounting pattern across those ranges, which is why a single lid works for both. If you've got a newer Ventline from 2008 or later, or an older pre-1995 unit, the hinge spacing is different and you'll want a different lid. When you're not sure, pop the old lid off and look for a brand stamp on the vent base, then measure the opening. It should come out right around 14 by 14 inches.

Installing it is a job most owners knock out in about fifteen minutes with nothing more than a screwdriver. The lid ships pre-assembled with its hinge, so you're not fighting tiny parts in the wind up on the roof. Pull the remains of the old lid, line the new hinge up with the existing mounting holes, and drive the included rust-resistant screws. Open and close it a couple of times to make sure it swings fully against the vent's crank or spring lift and seats flat when it's shut. You don't need sealant on the lid itself, since it rides above the vent flange rather than penetrating the roof. And while you're up there, it's worth a quick look at the butyl seal around the vent base and the condition of the roof membrane nearby.

Keep in mind what this part is and what it isn't. It's the everyday clear-span lid that lifts to let heat, humidity, and cooking steam escape. It's not a vent cover, a garnish ring, or a powered fan, and it doesn't include the crank mechanism. If your crank and screen are still good and you just need the lid that flips up, this is exactly the piece. It works the same whether the vent sits over the galley, the bathroom, or the main living area. Being standard white, it blends in with just about any RV roof without looking like a patch job.

Camco has been building RV parts since 1966, and the 40161 is one of those quiet, high-turnover parts that simply does its job. If you tow a lot of miles, it's smart to keep a spare in the storage bay. Vent lids never seem to fail at a convenient moment, and having the right 14 by 14 replacement already on hand beats calling around parts stores in an unfamiliar town.