Bluewater 19mm Ring Style Button - Stainless Steel

The Bluewater 19mm Ring Style Button in stainless steel is the replacement cap for Bluewater's 19mm LED-lit electronic push button switches. It's the part you press. Over time, that's the piece that takes the abuse. Salt spray, UV, thumbs, sunscreen, the occasional dock line dragged across the panel. The switch behind it can still work perfectly while the button face itself gets pitted, dull, or cracked. This button lets you bring that switch back to looking sharp without pulling the whole assembly and rewiring anything.

Let's be clear about what this is, because it matters for what you order. This is the button cap only, not the switch body and not the electronics. If you've already got a Bluewater 19mm push button switch mounted at the helm and the button is worn, or you just want a cleaner stainless look, this is your part. If you need the actual switch with the LED and the contacts, that's a different item in the Bluewater 19mm line. So check what you're replacing before you buy. Nine times out of ten, folks reach for this button because the switch works fine and only the face needs help.

Why stainless? Because a boat is a rough place for hardware. Salt air finds everything. A plated or plastic button on an open center console goes cloudy in a season or two. Stainless holds up. It resists corrosion, keeps its finish under constant spray, and it wipes clean when the salt builds up. On a helm where every other piece of trim is stainless, a matching stainless button keeps the panel looking intentional instead of patched together.

The ring style face is the other reason people pick this one. It's got that recessed ring around the button that reads clean and modern on a switch panel. If you've built out a bank of Bluewater 19mm switches for your nav lights, bilge, washdown, livewell, and horn, running the same ring style stainless button across all of them gives you that uniform, factory-rigged look. Mixed button styles on a panel always look like an afterthought. Matched ones look like you planned it.

Installation is about as simple as marine parts get. The button is sized for the 19mm Bluewater switch, so it seats onto the existing switch without any rewiring, soldering, or panel modification. You're swapping the face, not touching the circuit. If your switches are already in a proper 19mm panel cutout, this drops right into the system you've already got. One tip from folks who've done a bunch of these: work clean and dry, and make sure the old button is fully clear before seating the new one so it sits flush and even with the rest of the bank.

Who's this for? Anyone running Bluewater's 19mm push button switch system who wants to refresh a tired button or standardize the look of a helm. Center console owners cleaning up a salt-worn dash. Restorers bringing an older rig's switch panel back to life. Riggers building a new console who want every switch face to match. It's a small part, but it's the part your hand touches every time you flip on a light or kick the washdown, so it's worth having it look and feel right.

Bottom line: it's a stainless steel replacement button for the Bluewater 19mm LED-lit push button switches, ring style, sized at 19mm, sold individually. Order one to fix a single worn switch, or grab a handful to bring a whole panel up to a matched stainless finish. Either way, you're keeping a working switch in service and skipping the cost and hassle of replacing the entire unit.