Attwood White Casting Boat Seat, Marine Grade Vinyl

The Attwood casting seat is a low-profile fishing seat built for the front deck of a boat, where you sit down, plant your feet, and work a shoreline or a weed edge for hours at a time. It's a simple, honest piece of gear. No levers, no folding mechanism, no headrest. Just a molded seat wrapped in white marine-grade vinyl over a sturdy base, ready to bolt onto a pedestal and take a beating out on the water.

At 15 inches wide, 11 inches deep, and 6 inches tall, this is a compact seat, and that low 6-inch height is the whole point. A casting seat isn't a captain's chair. It keeps you sitting low and close to the deck so your center of gravity stays down and you've got a stable base to lean into on a cast. Anglers who spend the day on their feet and then want to take a load off between spots know exactly what this is for. It's the seat you drop onto while you re-tie, sort a tackle tray, or ride out a short run to the next flat.

Where does it fit? Jon boats, small aluminum fishing boats, bass boats, skiffs, and pontoons all make sense. Anywhere you've got a casting deck or a flat platform and a standard boat seat pedestal. The footprint is small enough to tuck onto a bow deck without eating up the whole platform, which matters on a 14 to 16 foot boat where every inch of standing room counts. If you fish shallow and cast all day, a low seat like this stays out of your way until you actually want to sit.

The cover is marine-grade vinyl, which is the right material for a seat that lives outdoors. It shrugs off water, wipes clean, and handles sun and spray far better than any indoor upholstery would. White keeps things cool and bright and matches most boat interiors. Like any light-colored vinyl, it'll stay looking sharp longer if you rinse it after a salt day and wipe it down now and then. A quick clean with mild soap and water is all it takes, and letting it dry before you cover the boat goes a long way.

Underneath the vinyl is a high-impact plastic base. That's what gives the seat its shape and its strength, and it's why a fixed, non-adjustable, non-foldable design like this holds up so well. Fewer moving parts means fewer things to rattle loose, corrode, or fail after a couple of seasons. You bolt it down once and it does its job. No hinges to seize up, no adjustment lever to snap off in the cold.

A quick word on mounting. This is the seat by itself. It's designed to sit on a standard boat seat pedestal, but the pedestal, base plate, and any mounting hardware are sold separately. If you're swapping out a worn casting seat, check that your existing pedestal pattern lines up before you pull the old one off. If you're building out a fresh casting deck, plan for a pedestal and mount to match. And measure your deck space, because that 15 by 11 inch footprint needs a clear spot with a little room around it for your feet.

There's no headrest on this one, and that's by design. A casting seat is meant to be low and out of the way, not a lounge chair. If you want back or head support for long idle runs, that's a different style of seat. But for active fishing, where you're up and down all day and want something that stays clear of your rods and your casting motion, this low-back, no-headrest shape is exactly what you want. It's the classic front-deck fishing seat, plain and simple, from a company that's been building marine gear for over a hundred years.