Attwood 99129 Stainless Swing Table Leg, 13 Inch

The Attwood 99129 is a stainless steel swing leg built to hold up a boat table without turning your cockpit into an obstacle course. It stands 13 inches at a fixed height, rides on a 1-inch diameter tube, and comes with everything you need to get it mounted: a stainless button lock and a mounting bracket. The foot wears a white rubber tip so it sits quiet and doesn't skate around when the boat rolls. If you've been running a folding table that never quite feels solid, this is the kind of upgrade that pays off every time you set out lunch.

The 13-inch height is the sweet spot for a lot of smaller boats. On a 20 to 24 foot center console, it puts a table at a comfortable seated height in the cockpit or up on the bow. It works well under a round teak or laminate top in that same size range. On bigger express cruisers with taller seating, you'll want to measure first, because a fixed 13-inch leg can sit low against a higher settee. Measure from your mounting surface to where you want the tabletop to land, and if that number is close to 13 inches, you're in business.

One more thing on fit. This leg pairs nicely with a 36-inch round top, which is a popular size for a cockpit table on this class of boat. Just check your clearance before you commit. A 1-inch tube plus a table overhang can crowd a narrow walkway, so make sure people can still get past when the table's set up. On an open cockpit it's a non-issue, but tighter layouts are worth a second look.

Here's what makes a swing leg worth it. When you're done eating, the table doesn't have to come all the way off and go find a locker. The leg swings out of the way and the whole setup stows fast, so you get your deck space back for fishing, boarding, or just moving around. That's the whole point on a smaller boat where every square foot of cockpit counts. The stainless button lock holds the leg firmly in the up position and releases with a push when you're ready to knock it down.

Mounting is straightforward, but do it right the first time. The bracket lands best on a flat fiberglass surface. If your console or sole has a curve to it, plan on a shim or a backing block so the base sits flush and the leg doesn't bind as it swings. Don't just run screws into a thin plywood core. Through-bolt the bracket to a proper backing plate under the deck so it can't pull out under load. And before you drill your final holes, dry-fit the table and swing it through its full arc. Boats with side rails or a tight walkway can limit how far the leg travels, and you want to catch that before the bit goes through the gelcoat.

Stainless steel is the right material for a part that lives out in the weather. It shrugs off spray and sun far better than a plated or painted leg. That said, salt is relentless. Give the button lock a rinse and a shot of light marine grease every month or so, especially if you keep the boat in salt water, and it'll keep releasing clean instead of freezing up on you. The white rubber tip protects your deck and the table foot, but keep an eye on it over time and replace it if it starts to scuff or wear.

For the money, the Attwood 99129 is a simple, honest piece of hardware that does one job and does it well. It's stainless where it counts, it comes with the lock and bracket in the box, and it's sized for the boats most of us actually run. Set it up once, take care of the lock, and it'll be holding your table steady for a lot of seasons.