Arcon

Arcon 20669 12V LED Ceiling Light, Clear Lens, 8 x 4-3/4

SKU: 2011549 · UPC: 088805206698 · MPN: 20669
★★★★★ 4.7 · 0 reviews
Authorized dealer
$32.69
or 4 payments of $8.17 with Affirm · See disclosures
Low stock — 1 left — Ships today Pickup Monday · Fort Lauderdale (FL)
SAME-DAY SHIPPING · 14:23 EST
Order in time, ships today
Ships from your nearest warehouse. UPS Ground 2–4 business days.
Free shipping
Orders $500 or more
Free returns
Within 30 days
Same day shipping
Order before 3 PM (EST)
Ask anything
We're here to help
$32.69
02 · Overview

Arcon 20669 12V LED Ceiling Light, Clear Lens, 8 x 4-3/4 — Product description

The Arcon 20669 is a single 12 volt LED ceiling light with a clear lens and a bright white bulb. It measures 8 inches by 4-3/4 inches, which makes it a solid overhead pick for cabins, galleys, and heads where you want clean, bright light.

The Arcon 20669 is a single LED ceiling light with a rectangular footprint, 8 inches long and 4-3/4 inches wide. It runs on 12 volts, so it ties straight into the DC system on most small boats, campers, and trailers. You get a bright white bulb behind a clear lens. One fixture per pack.

Where does a light like this earn its keep? Think cabin overheads, a galley counter, the head, a V-berth reading spot, or that locker where you keep fumbling for a flashlight. Anywhere you've got a bit of overhead space and a 12 volt feed nearby, a flat ceiling-mount LED makes sense. It's a single light, so if you're lighting a bigger cabin you'll want a few of them spaced out.

A clear lens with a bright white bulb is a straightforward, punchy combination. It gives you clean light for reading charts, sorting gear, or finding the tackle box at night. In a small enclosed space it can feel sharp, so think about where you're putting it. Over a work area or a galley counter, great. Directly above a bunk, you may find it harsher than you'd like.

Measure before you order. The fixture is 8 inches by 4-3/4 inches, a fairly generous footprint for an overhead. If you're replacing an old fixture, hold a tape against the existing cutout and screw holes. Older incandescent fixtures rarely share the same footprint, so you may end up filling old holes or adding a backing plate. Overhead panels on a lot of boats are thin, so pick screws that won't poke through to the deck above or run into wiring behind the liner.

It's a 12 volt unit, so treat it like any other DC load. Keep polarity straight, run it off a fused circuit, and mark the positive lead before you take the old fixture down. LED lights are usually polarity sensitive, so reversed leads typically means it just stays dark. That beats letting the smoke out, but it still wastes an afternoon. On a long run from the panel, thin wire can cause voltage drop and a dim light up at the bow. Keep the run short or step up the wire gauge. And this is a 12 volt light only. If your boat runs 24 volt, you'll need a converter.

Boats sweat. Overheads collect condensation, and in some spots they catch spray. We don't have a waterproof or ingress rating listed for this fixture, so don't assume one. Mount it in a dry cabin area and seal around the screws and the back of the fixture where moisture could creep in. Treat it like an interior light and it'll treat you well.

We also don't have dimming information for this light, so plan on it being switched on and off only. If you're mixing it with older warm incandescent dome lights on the same circuit, the color difference will show. Bright white next to yellow looks unfinished. Swap the neighbors too if you can, or keep the two kinds in separate zones of the boat.

A quick word on planning the install. Dry-fit the fixture against the overhead before you drill anything, and trace where the wire will route behind the liner. Cut the power at the panel first. Crimp and heat-shrink your connections so they hold up to vibration and damp air, and tidy the wire so it can't chafe on a sharp edge. Ten extra minutes up front saves a headache later.

The Arcon part number is 20669 and the UPC is 088805206698. It's sold as a single, so if you need four lights, order four. It's a simple upgrade that swaps a dim old bulb for cleaner, brighter light without turning into a big project. Give us a call if you're not sure about fit and we'll help you sort it out.

Key Features

  • 12 volt operation, so it ties right into a typical boat, camper, or trailer DC circuit
  • LED light source with a bright white bulb for clean, punchy light
  • Clear lens for maximum brightness over galley counters and work areas
  • 8 inch length by 4-3/4 inch width footprint, so measure your cutout before ordering
  • Ceiling-mount single light, one fixture per pack, add one per zone
  • Arcon part number 20669 makes reordering easy when you're lighting more than one space

Why Buy from NVN Marine

  • Authorized Arcon reseller, full manufacturer warranty
  • NMEA member and ABYC certified, advice from real boat techs
  • Same-day shipping before 3 PM ET on in-stock items
  • NY headquarters and Fort Lauderdale flagship retail store
NVN Marine — 11 W State Road 84, Fort Lauderdale, FL 33315 Available for pickup at our Fort Lauderdale store (Monday) $32.69
03 · The numbers

Technical specifications

Title LED Ceiling Single Light, Clear Lens, 8 Inch Length x 4-3/4 Inch Width, Bright White Bulb, 12 Volt, Single
Brand Arcon
Manufacturer Part Number 20669
UPC 088805206698
Light Type LED
Mounting Ceiling
Lens Clear
Length 8 in
Width 4-3/4 in
Bulb Color Bright White
Voltage 12 Volt
Quantity Single
04 · Before you buy

Frequently asked questions

What voltage does the Arcon 20669 run on?

It's a 12 volt LED ceiling light. For a 24 volt system you'd need a converter.

How big is this light?

The fixture measures 8 inches in length by 4-3/4 inches in width.

Does it have a clear or frosted lens?

It has a clear lens.

What color is the light?

It uses a bright white bulb.

Does one order come with a single light or a set?

It's sold as a single light. Order one per location you want to light.

Is it waterproof?

We don't have a waterproof or ingress rating listed for this fixture. Mount it in a dry cabin area and seal around the screws and the back.

Can I dim it?

We don't have dimming information for this light, so plan on switched on/off use only.

Will it fit the cutout from my old fixture?

Measure first. This one is 8 inches by 4-3/4 inches, and older incandescent fixtures often have a different footprint, so you may need to fill old holes or add a backing plate.

What's the manufacturer part number?

The Arcon part number is 20669 and the UPC is 088805206698.

Does it work with a standard boat 12 volt panel?

Yes, it's a 12 volt light. Wire it to a fused circuit, keep polarity correct, and keep the wire run short to avoid voltage drop.

05 · Customer voices

Customer reviews