Navico Cruise/Hook2 83/200 Skimmer Transom Mount Transducer

Enhance Your Fishing Experience with the Cruise/Hook² 83/200 Skimmer Transducer

Whether you're chasing trophy bass in shallow waters or scanning deep offshore for structure, the right transducer makes all the difference. This skimmer-style transom mount transducer, designed specifically for Navico's Cruise and Hook² series fishfinders, delivers reliable dual-frequency performance at 83/200 kHz. Its robust build and easy installation ensure crystal-clear sonar images right from your boat's transom, helping you spot fish, wrecks, and contours with precision.

Key Features That Set It Apart

• Dual 83/200 kHz Frequencies: The 83 kHz cone offers wide-area coverage for locating fish schools quickly, while 200 kHz provides high-definition detail at higher boat speeds—perfect for trolling or cruising.
• Skimmer Design: Low-profile housing minimizes drag and water turbulence, keeping your readings accurate even in rough conditions.
• Transom Mount Simplicity: Mounts securely to most hulls with included hardware, positioning the ceramic element just below the waterline for optimal performance.
• 19.5-Foot Cable with 9-Pin Connector: Plenty of length for clean routing to your display unit, plug-and-play compatibility without adapters.
• Depth Capabilities: Reliable down to hundreds of feet, depending on your fishfinder model and water conditions.

Why Boaters Trust This Transducer for Cruise and Hook² Units

Navico engineered this transducer to pair seamlessly with entry-level yet powerful fishfinders like the Hook² series from Lowrance and Cruise models from Simrad. It's not just about basic depth soundings—users report sharper fish arches, better bottom separation, and fewer dropouts compared to generic alternatives. The plastic housing withstands UV exposure, saltwater corrosion, and impacts from trailering, making it a long-term investment for weekend warriors and guides alike.

Imagine idling over a suspected honey hole: the wide 83 kHz beam sweeps a broad path, marking baitfish clusters, then switch to 200 kHz for pinpoint targeting. It's this versatility that keeps anglers coming back, season after season.

Effortless Installation Guide

Installing this transducer is straightforward, even for DIYers. Here's a step-by-step approach based on real-world setups:

1. Clean and sand the transom area for a strong bond.
2. Select a spot 1/3 from the stern, deadrise-matched for your hull.
3. Drill pilot holes, secure with stainless screws, and apply marine sealant.
4. Route the cable through the hull or along gunwales, avoiding heat sources and sharp edges.
5. Test at varying speeds to fine-tune angle—aim for a slight downward tilt.

Pro tip: Bracket-mount it first for adjustments before permanent install. Most setups take under an hour.

Compatibility and Performance Tips

Tailored for Cruise and Hook² displays, it shines on deadrise angles from flat to 20 degrees. For best results, calibrate your unit's sensitivity and pair with CHIRP-enabled models if available. Maintain it by rinsing after saltwater use and inspecting the face for marine growth—keeps readings crisp year-round.

Avoid common pitfalls like mounting too high (loses bottom lock) or near strakes (causes interference). With proper setup, expect consistent performance across freshwater lakes, rivers, and coastal bays.