Lowrance Bullet/SplitShot Transom Mount Bracket

Enhance Your Fishfinder Setup with the Perfect Transom Mount

Picture this: you're out on the water, lines in the water, and your sonar readings are crystal clear, revealing every structure and fish below. The secret to reliable performance from your Lowrance Bullet or SplitShot transducer lies in a secure, properly positioned mount. This dedicated transom mount bracket simplifies the process, ensuring your transducer stays locked in place amid waves, wakes, and rough conditions.

Crafted from robust, corrosion-resistant materials, it withstands the harsh marine environment while offering straightforward installation. No more guesswork or makeshift solutions—get pro-level results with hardware designed specifically for these popular transducers.

Key Features That Stand Out

• Precision Fit: Tailored exclusively for Bullet and SplitShot models, guaranteeing a snug, vibration-free hold.
• Easy Adjustment: Adjustable angles let you dial in the ideal downward view for optimal sonar coverage.
• Durable Build: Engineered to endure saltwater exposure, UV rays, and constant submersion without warping or loosening.
• Streamlined Design: Low-profile setup minimizes drag and keeps your boat's hull clean for better performance.
• Universal Bolt Pattern: Compatible with standard transom setups on fiberglass, aluminum, and wood hulls.

Compatibility at a Glance

This bracket pairs seamlessly with Lowrance HOOK series units equipped with Bullet (single-beam) or SplitShot (CHIRP/downscan combo) transducers. It's the go-to accessory for anglers upgrading their fishfinders or replacing worn mounts, fitting boats from kayaks to center consoles.

Step-by-Step Installation Guide for Flawless Setup

Installing your transducer has never been simpler. Follow these proven steps for a rock-solid mount that delivers accurate readings every time:

1. Prep the Surface: Clean the transom thoroughly, removing dirt, wax, or old adhesive. Mark the bracket's position 1/3 from the hull bottom to transom top for best water flow.
2. Drill Holes: Use the bracket as a template. Drill pilot holes to prevent cracking, especially on thinner hulls.
3. Secure the Bracket: Fasten with stainless steel bolts and backing plates. Apply marine sealant around holes for watertight integrity.
4. Attach Transducer: Slide the transducer into the bracket slot and tighten thumb screws. Adjust tilt so the sonar beam points 10-20 degrees down.
5. Route Cable: Zip-tie the cable along the transom, avoiding sharp edges or hot engine parts. Test in water before full-speed trials.
6. Final Check: Launch and verify readings—no air bubbles or interference mean you're set.

Pro Tip: Avoid mounting directly behind strakes or trim tabs, which disrupt water flow and muddy your sonar image.

Maximize Performance and Longevity

Beyond installation, periodic checks keep your setup humming. Rinse with fresh water after saltwater use, inspect for loose hardware, and reapply sealant annually. Anglers report fewer dropouts and sharper fish arches when using this bracket, thanks to its stable positioning that maintains consistent transducer depth—even at trolling speeds up to 30 mph.

Whether you're chasing bass in shallow bays or walleye in deep reservoirs, this mount elevates your electronics game, turning good trips into legendary ones.

Frequently Asked Questions