Raymarine Transducer Extension Cable f/CPT-60 Dragonfly Transducer - 4m

Extend your sonar capabilities on the water with confidence using this genuine Raymarine extension cable designed specifically for the CPT-60 transducer paired with Dragonfly fishfinders. Boaters and anglers often face the challenge of positioning their transducers just right for optimal readings while keeping electronics tucked away in dry, secure spots. This 4-meter cable bridges that gap seamlessly, giving you the flexibility to mount your CPT-60 farther aft or customize your setup without signal loss or hassle.

Unlock Flexible Mounting Options

Whether you're retrofitting an older boat or fine-tuning a new install, this extension preserves the crisp CHIRP performance of your Dragonfly unit. The CPT-60's dual-element design excels at revealing fish arches, bottom structure, and water column details—no matter where you place it. By adding length, you avoid messy cable routing through bulkheads or along gunwales, reducing clutter and wear from constant exposure to saltwater spray.

• Signal Integrity Maintained: Engineered with shielded conductors to minimize interference from motors or electronics, ensuring reliable depth, temperature, and sonar returns.
• Marine-Tough Build: UV-resistant jacket withstands harsh sun, waves, and chemicals common in boating environments.
• Plug-and-Play Simplicity: Connects directly between your CPT-60 transducer and Dragonfly display—no tools, splicing, or adapters needed.

Perfect for Real-World Boating Scenarios

Picture this: You're chasing stripers along a rocky shoreline, but your Dragonfly's ideal helm position is amidships, far from the transom. Short cables force compromises; this extension lets you position the transducer dead-center for the cleanest water flow, dodging prop wash and air bubbles that muddy readings. Kayak anglers love it for reaching bow-mounted setups, while offshore cruisers use multiples chained together for extended runs to transducers on stabilizers or outriggers.

Pro tip from seasoned installers: Route the cable along existing wiring channels and secure with zip ties every 30cm to prevent chafing. Pair it with dielectric grease on connectors for extra corrosion protection in brackish waters.

Enhance Your Dragonfly Ecosystem

Raymarine's commitment to modular marine tech shines here. This cable integrates flawlessly with Dragonfly's ecosystem, supporting everything from shallow-water structure scanning to deep-water bait schools. It's not just wire—it's an investment in clearer screens, better catches, and less time troubleshooting vague sonar ghosts caused by poor cable management.

Installation in Minutes

1. Power down your Dragonfly and disconnect the CPT-60 transducer cable.
2. Plug one end of the extension into the transducer's 8-pin connector.
3. Connect the other end to your Dragonfly's transducer port.
4. Strain-relief the connections with cable clams or heat-shrink tubing.
5. Test in water: Verify CHIRP sweeps show consistent bottom tracking and fish ID.

Avoid common pitfalls like overtightening mounts or exposing ends to bilge water—proper setup keeps performance peaking season after season.