LENCO 12"X12" EDGEMOUNT KIT W/O SWITCH TT12X12ENS
It will be shipped by UPS Ground.
Available Stock : 41
- 12-volt actuator with 6-pin lead and Deutsch connector (2).
- Stainless steel decorative blade (2).
- 20' actuator extension wiring harness with Deutsch connector (2).
- Upper mounting bracket with gland seal.
- Lower mounting bracket.
LENCO 12"X12" EDGEMOUNT KIT W/O SWITCH TT12X12ENS PRODUCT DESCRIPTION
12" x 12" Edge Mount Trim Tab Kit without Switch Kit -12V
Lenco Electric Edge Mount Trim Tab Kits make your boat ride smoother, dryer, faster and with increased safety whether on a small skiff or a large yacht. The Lenco ball screw design is more reliable, three times more powerful and features an instant response, which makes them very user friendly compared to typical hydraulics. Lenco fast response electric actuators are fully submersible with all plug & play waterproof Deutsch connections. Edge Mount actuators mount at the trailing edge of the plane, requiring 4" (10.16 cm) less transom height than Lenco standard mount trim tabs.
- 2 each of 12-gauge stainless steel trim tab blades
- 2 each of #15054-001 actuator with 6' leads & Deutsch plugs
- 2 each of #30133-103 20' actuator extension wiring harnesses
- 2 each of #15085-001 (116) upper mounting brackets with gland seal
- 2 each of #50014-001 (119) lower mounting brackets
- 1 each of the Lenco owner’s / installation manual
- All necessary stainless steel mounting hardware
- Suggested Boat Length: 17' to 30'
- Length of Tab: 12"
- Width of Tab: 12"
- Hinge Height: 2"
- Minimum Transom Height: 11"
- Blades: 12 Gauge Stainless Steel
- Finish: Smooth
- Switch Kit: Sold Separately
- Class: Fuel Efficient
- Compliance: CE Certified
- Compatibility: Any Boat
- Actuators: 12-volt
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
The edge mounts the actuator on the rear edge of the aircraft, and the required crosspiece height is 4 inches less than the standard mounting frame. Trim wings are the most important difference between how you ride a boat and how you ride. They are optional on some ships, but should be equipped as standard with powerful trim and tilt functions. Lenco's trimming sheet makes your boating smooth, dry and faster, and improves safety. Whether it is on a small boat or a large yacht, Lenco's ball screw design is more reliable, three times stronger, and has instant response Capabilities, they are very easy to use compared to typical hydraulic systems. We also like the oil-free, environmentally friendly features, instant response electric actuators for precise control; all parts are completely immersed in water, no maintenance, and sealed for life; self-locking ball screw will not drift, even when retreating When the stainless steel decorative sheet cut by No. 12 laser is flat, after years of use, the high-strength corrosion-resistant mounting seat also looks good, clean, and saves time and space.
Lenco 12 x 12 Edge Mount Trim Tab Kit w/o Switch Kit 12V Related ProductsLENCO UPPER MOUNTING BRACKET W/ GLAND SEAL
LENCO COMPACT UPPER MOUNTING BRACKET (2 SCREW 1 WIRE)
LENCO STANDARD UPPER MOUNTING BRACKET (3 SCREW 1
LENCO STANDARD LOWER MOUNTING BRACKET (3 BOLT)
TECNOSEAL R1 RUDDER ANODE ZINC 1-7/8" DIAMETER
TECNOSEAL R2 RUDDER ANODE ZINC 2-13/16" DIAMETER
TECNOSEAL R3 RUDDER ANODE ZINC 3-3/4" DIAMETER
TECNOSEAL R1AL RUDDER ANODE ALUMINUM 1-7/8" DIAMETER
TECNOSEAL R2AL RUDDER ANODE ALUMINUM 2-13/16" DIAMETER
TECNOSEAL R3AL RUDDER ANODE ALUMINUM 3-3/4" DIAMETER
Save $166 when you buy the LENCO 12"X12" EDGEMOUNT KIT W/O SWITCH TT12X12ENS for only $495 from NVN Marine! Same day shipping before 3pm.