Lenco 18" x 14" Standard Performance Trim Tab Kit w/o Switch Kit 12V

18" x 14" Standard Performance Trim Tab Kit w/o Switch Kit- 12V

Upgraded electro-polished trim blades with stouter 1/4" diameter hinge pin make these Performance Trim Tab Kits a cut above the base level Lenco Standard Mount Kits. Equipped with the same fast response electric actuators for precise control. Fully submersible with all Plug & Play Deutsch connections. Blades are Electro-Polished 12 gauge - 304 SS with 1" turned up edges (the 16" x 12" and the 18" x 14" have an 85 degree inside taper) and 1/4" diameter hinge pin. Kit includes Standard Actuators with 5/16" SS bolts. The actuators mount at the trailing edge of the blades

Kit Contents:

• 2 each of 12-gauge stainless steel Electro-Polished trim tab blades
• 2 each of #15054-001 actuators with 6' lead and Deutsch plugs
• 2 each of #30133-103 20' actuator extension wiring harnesses
• 2 each of #15085-001 (#116) upper mounting bracket with gland seal   
• 2 each of #50014-001 (#119) lower mounting bracket 
• 1 each of the Lenco owner’s / installation manual
• All necessary stainless steel mounting hardware

Specifications:

• Suggested Boat Length: 22' to 40'
• Length of Tab: 18"
• Width of Tab: 14"
• Minimum Transom Height: 11"
• Blades: 12 Gauge Stainless Steel
• Finish: Electro-Polished
• Switch Kit: Sold Separately
• Class: Fuel Efficient
• Compliance: CE Certified
• Compatibility: Any Boat
• Actuators: 12-volt

WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Fully submersible, precisely controlled electric actuator. All plug-and-play Deutsch connections. The blade is made of 12# electropolished 304 stainless steel, inclined up 1 inch (16x12 and 18x14 blades have an internal taper of 85), and are equipped with a 1/4 inch diameter stainless steel hinge. Stainless steel mounting screws. Minimum tail plate height: 9 inches L type -13.5 inches, 12 inches and longer models -11 inches Kit includes: 12 volt standard actuator (2), with 5/16 inch stainless steel mounting bolt 6'wire and Deutsch connector 20' actuator extension wiring harness (2) with Deutsch connector. Stainless steel electro-polished trim -12 gauge (2). Stainless steel mounting hardware. The switch kit is sold separately.
SKU: NVN-29265
MPN: 15040-101
UPC: 874847004626