Sierra 18-3471 3471 Yamaha Water Pump Repair Kit

Keep your Yamaha outboard running cool and reliable with the Sierra 18-3471 water pump repair kit. Designed for boaters who tackle maintenance themselves, this kit breathes new life into worn-out water pumps, preventing overheating and costly engine damage during those long days on the water. Whether you're prepping for fishing season or fixing a mid-trip hiccup, it's a smart, straightforward upgrade that restores full cooling efficiency.

Why Rebuild Your Yamaha Water Pump Now?

Water pumps on outboards take a beating from sand, salt, and constant impeller wear. A failing pump might not show obvious signs at first—just a slight temp rise or weaker stream from the tell-tale—but ignore it, and you're risking warped heads or seized pistons. This kit targets the core components: impeller, housing wear plate, and seals. Swap them out proactively every 1-2 years or 100-200 hours, depending on your boating conditions, and you'll extend engine life significantly.

Key Components for a Complete Rebuild

• High-quality impeller: Flexible neoprene construction resists cracking in ethanol-blended fuels common today.
• Stainless steel wear plate: Minimizes drag and extends impeller life in gritty water.
• O-rings and gaskets: Precision-molded for leak-free seals that hold up in harsh marine environments.
• Key and liner: Ensures positive drive without slippage under load.

Unlike basic impeller-only kits, this full repair set addresses multiple failure points, giving you pro-level results without the dealership bill.

Perfect Fit for Popular Yamaha Models

Engineered as a direct OEM replacement, the Sierra 18-3471 slots right into a range of 2-stroke Yamaha powerheads from the 40HP to 70HP class. It matches factory specs for models like the 48, 50, 60, and 70HP variants from the 1980s through early 2000s. Always cross-check your lower unit to confirm—most have the water pump nestled above the gearcase, accessible with basic tools.

Step-by-Step Installation Tips for DIY Success

1. Prep work: Tilt the motor up, drain the water from the lower unit, and remove the gearcase (four bolts usually).
2. Disassemble: Pry off the old impeller with needle-nose pliers—twist gently to avoid shaft damage.
3. Clean thoroughly: Scrape corrosion from the housing; a wire brush works wonders here.
4. Assemble new kit: Lubricate the impeller with marine grease, align the key, and torque the wear plate to spec (around 70-90 in-lbs).
5. Test run: Flush with fresh water, check for strong tell-tale flow, and monitor temps on your first outing.

Expect 1-2 hours for experienced hands. Pro tip: Warm the impeller in hot water for 5 minutes—it slips on easier and reduces tears.

Real Benefits for Everyday Boaters

Sierra parts stand out for their balance of affordability and durability, using materials that shrug off UV exposure and biofuel corrosion better than some generics. Boaters report cooler idle temps and consistent performance after install, especially in shallow bays or saltwater runs. It's not just a fix—it's maintenance that pays dividends in reliability and resale value.

Common pitfalls? Skipping the grease or reusing old O-rings leads to leaks. And if your pump housing is pitted beyond repair, consider a full lower unit inspection to avoid repeat work.

Frequently Asked Questions

Ready to get back on the water without worries? This kit delivers peace of mind, one cooled engine at a time.