Sierra 18-3433 3433 Yamaha Water Pump Repair Kit

Keep your Yamaha outboard running cool and reliable with the Sierra 18-3433 water pump repair kit, a trusted choice for boaters tackling impeller wear and cooling system glitches. Overheating is every angler's nightmare on the water—low water flow from a failing pump can sideline your adventures fast. This kit delivers everything needed to restore full pumping power, matching the performance of factory originals without the premium hassle.

Built for Durability and Precise Fit

Crafted from high-grade neoprene and stainless components, the Sierra kit withstands the harsh marine environment—saltwater corrosion, high RPMs, and constant submersion. It's engineered as a direct replacement for common Yamaha models, ensuring seamless integration without modifications. Boaters rave about its longevity, often outlasting stock parts in demanding conditions like offshore fishing or long hauls.

Key Components for Complete Rebuild

• High-performance impeller for maximum water flow
• Durable wear plate to prevent premature erosion
• Precision-machined housing for optimal alignment
• Essential gaskets, seals, and O-rings for leak-proof assembly
• Key and liner for secure, vibration-resistant installation

Unlike piecemeal fixes, this all-in-one solution saves time and guesswork, getting you back on the water quicker.

Spot the Warning Signs Early

Catch pump failure before it escalates. Watch for these red flags during your pre-launch checks:

• Steam or unusual exhaust heat indicating poor cooling
• Reduced pee stream from the tell-tale outlet
• Visible impeller chunks in the water intake
• Overheating alarms triggering mid-run
• Rubber bits floating near your prop

Addressing these promptly prevents engine damage, which could cost far more than a simple rebuild.

Step-by-Step Installation Tips

No shop required—this DIY-friendly kit installs in under an hour with basic tools. Here's a pro rundown:

1. Drain and flush the cooling system; remove the lower unit.
2. Extract the old impeller using needle-nose pliers—twist counterclockwise.
3. Clean mating surfaces thoroughly to ensure a tight seal.
4. Lubricate new O-rings with marine grease; install liner and key first.
5. Slide in the impeller (hump facing up), add wear plate, and torque housing bolts evenly.
6. Reassemble, prime the system, and test-run at idle to verify flow.

Pro tip: Always replace the gear lube while you're in there for peak lower unit health.

Long-Term Maintenance for Peak Performance

Extend the life of your rebuild with smart habits. Flush after every saltwater trip using a hose adapter, inspect annually for wear, and carry a spare impeller on multi-day outings. Pair with a zinc anode refresh to shield against electrolysis. These steps keep cooling efficient, fuel burn low, and your Yamaha humming season after season.