Lewmar Pro-Series Control Arm Kit

Enhance Your Anchoring Reliability with the Lewmar Pro-Series Control Arm Kit

Every seasoned boater knows the frustration of a windlass that hesitates during those critical anchoring moments. Whether you're dropping hook in a crowded bay or pulling up in choppy seas, the control arm in your Lewmar Pro-Series windlass plays a pivotal role in smooth operation. This replacement kit restores that precision, tackling wear from constant exposure to saltwater, UV rays, and mechanical stress.

Crafted from durable, corrosion-resistant materials, it slots seamlessly into your setup, ensuring the up/down switch responds crisply every time. No more second-guessing your anchor rode—get back to confident anchoring with a component built for marine harshness.

Perfect Fit for Pro-Series Models

Designed exclusively as a direct replacement for Lewmar Pro-Series 700 and 1000 windlasses, this control arm kit eliminates compatibility guesswork. These models are favorites among mid-sized yachts and sailboats for their robust performance in depths up to 100 meters with chain sizes from 6mm to 10mm. If your windlass is showing signs of control lag—sticky buttons or inconsistent response—this is the targeted fix.

• Pro-Series 700: Ideal for lighter vessels needing reliable short drops.
• Pro-Series 1000: Powers through heavier loads on larger boats.

It's sold as a single unit, so stock up for both port and starboard sides if your boat runs dual controls.

Key Features That Stand Out in Real-World Use

Unlike generic aftermarket parts that might compromise on fit or longevity, this genuine Lewmar component shines with:

• Precision Engineering: Exact OEM tolerances for plug-and-play installation, minimizing downtime.
• Weatherproof Design: Seals out moisture and salt, extending service life in harsh coastal environments.
• Ergonomic Grip: Textured surface for gloved hands, preventing slips during rough retrieves.
• Quiet Operation: Reduces switch chatter, a common complaint on worn arms.

Boaters report fewer electrical glitches post-replacement, as the arm's contacts stay clean and responsive longer.

Installation Insights from Deck Hands

Swapping out a control arm is a straightforward DIY for anyone comfortable with basic tools—no need for a full windlass teardown. Start by powering down your DC circuit, remove the old arm via its retaining clips or screws, and snap in the new one. Clean contacts with electrical spray for optimal conductivity.

Pro tip: While you're in there, inspect the circuit board for corrosion. Test in shallow water before your next offshore run. Most installs take under 30 minutes, keeping your boat ready without yard fees.

"Replaced both arms on my Pro 1000 after a season in the Med—night and day difference in responsiveness." – Experienced skipper feedback.

Maintenance Tips to Maximize Longevity

To keep your new control arm performing season after season:

1. Rinse with fresh water after every saltwater outing.
2. Apply dielectric grease to contacts annually.
3. Avoid standing water on deck controls—route drips away.
4. Check for play during annual haul-outs.

Pair it with Lewmar's full maintenance schedule for windlasses to prevent chain jams or motor strain downstream.

FAQ