Camco AccuLevel RV Bubble Level | Screw-On

The Camco AccuLevel takes the guesswork out of setting up your rig. It's a single bubble level that reads side-to-side and front-to-rear at the same time, so one quick look tells you which way you're leaning and by how much. No walking around the coach with a torpedo level. No crawling under the trailer. You pull into the site, glance at the bubble, and you know exactly what needs to come up.

Here's why that matters. A round bubble level reads a full 360 degrees at once. The bubble drifts toward the high corner, so you can see both axes in a single glance instead of checking one direction, then repeating for the other. That's the whole point of the AccuLevel. It's dead simple, and simple is what you want when you're tired, it's getting dark, and you just want the camper level so you can start dinner.

This version mounts with screws, so it stays put for good. We like putting one on the A-frame or tongue up front where you can see it from the driver's seat or while you spot from outside. A lot of folks run two, one reading side-to-side and another catching the rest. But because this one reads both directions, a single well-placed unit often does the job on its own. Pick a flat spot, make sure the rig is already sitting level when you install it, then drive the screws. Set it on a surface that isn't true and every reading after that will be off, so take the extra minute to get the mounting spot right.

Why fuss over level at all? A few reasons that actually bite you. An absorption fridge wants to sit close to level to cool properly, and running it off-kilter for long stretches can shorten its life. Off-level bunks make for a lousy night's sleep, with everybody rolling to one side of the bed. Doors and drawers swing open or won't latch right. And if your rig has slide-outs, they seat and seal far better on a level floor. Get the coach level first and the rest of the setup goes smoother.

Pair it with a set of leveling blocks or ramps and setup gets even faster. Read the bubble, spot the low side, and stack blocks under the low tires or drive the low side onto a ramp until the bubble centers. One mark off usually means you need to raise that side about an inch, so you can eyeball how many blocks to grab before you even step out. Then set your stabilizer jacks once you're level, not before.

The AccuLevel earns its keep on travel trailers, fifth wheels, truck campers, pop-ups, and motorhomes. Anywhere you park and need to know your attitude at a glance. And it's not only an RV tool. If you keep a boat on a trailer or in dry storage over the winter, a bubble level on the frame helps you set a slight bow-down angle so rain and melt drain off the cover instead of pooling. Same idea, same handy little gauge.

A couple of honest notes. This is a screw-mount unit, so it's a permanent install, not something you'll move from rig to rig. Give the bubble a sanity check against a known-level surface when you first put it on, and you'll trust it for years. The housing lives out in the sun and weather up on the frame, so if your rig sits outside year-round, plan on it being a wear item eventually. For what it costs, that's an easy trade. You get level in seconds, every single time you set up.