Camco 57282 RV Grill Replacement Hose, 10 ft QC

The Camco 57282 is the exact replacement hose for the Camco 5500 SS RV grill. If your original line has cracked, kinked, or started weeping at the fittings, this is the part that gets you back to grilling. Ten feet of propane hose, quick connect on both ends, ready to drop in and go.

There's nothing like pulling into a site, getting the rig leveled, and having the grill hooked up in under a minute while the burgers are still coming up to temp. That's the whole point of a quick-connect setup, and a good hose is what keeps it working. When the original line starts to age, you don't want to limp through a whole season with a hose that weeps at the ends or feels stiff every time you reach for the coupler. Swap it once and get back to cooking.

Here's what makes it easy. Both ends are quick-connect fittings, so there's no wrenching on threads and no fussing with thread tape. You push the coupler on, feel it click, and you're hooked up. When you're done for the night, you disconnect just as fast and coil it away. That matters when you're setting up and breaking down a site on a schedule.

The ten-foot length is the sweet spot for most RV setups. It reaches from the low-pressure propane quick-connect port on the side of the coach out to where you actually want the grill, off to the side of the picnic table and clear of the awning and the door. You're not fighting a short hose that drags the grill back toward the rig, and you're not tripping over a pile of excess line coiled on the ground.

A couple of things to know before you buy. This hose ships without a regulator and without thermal protection, and that's by design. It's meant to run off the regulated, low-pressure quick-connect system your RV already has. You don't want to feed it straight tank pressure. Running it off an unregulated tank can cause flare-ups the first time you light the grill. Pair it with your RV's existing regulator or the grill's low-pressure quick-connect port and you're set.

No thermal protection just means the hose doesn't carry a built-in heat shield. Keep it routed away from the hot side of the grill and away from any exhaust, and don't let it rest against metal that gets hot. Basic hose sense. Give it a clear path and it'll do its job for a long time.

Install is about as simple as it gets. Make sure the propane is off at the source first. Push the quick-connect end into the port until it clicks, do the same at the grill, then turn the gas back on and brush a little soapy water over both fittings. If you see bubbles, the coupler isn't fully seated. Reseat it, test again, and you're cooking. We tell every customer to do the soapy-water check on any propane connection. It takes ten seconds and it's cheap insurance.

Storage is the other place to be a little careful. Quick-connect hoses can kink right at the fitting if you coil them too tight. Loop it wide, don't crank it down against the coupler, and it won't crack at the crimp. Done right, this is a hose you set and forget for seasons of weekend cookouts.

So who's this for? Anybody running the Camco 5500 SS RV grill who needs a fresh hose, or a spare to keep in the storage bay for the trip when the old one finally gives out. It's the correct length with the correct fittings, so you're not adapting anything or guessing at couplers. It just fits, and that's the whole point.