Camco PowerGrip 55194 50-Amp 15-Foot RV Power Cord, NEMA 14-50

If you're running a 50-amp rig, you already know the shore cord is the one piece of gear you touch every single time you pull into a site. The Camco PowerGrip 55194 is built for exactly that. It's a 15-foot, 50-amp power supply cord with a NEMA 14-50 male plug on one end and a matching 14-50 female connector on the other, so it drops straight onto any standard 50-amp pedestal and into your 14-50 inlet.

The heart of it is the wire. This is 6/8 gauge STW cable, which means the current-carrying conductors are heavy enough to move a full 50 amps without cooking themselves. That matters. A 50-amp service can pull real current when the air conditioners, the water heater, and the microwave all come on at once, and thin wire is where you get voltage drop and warm plugs. Heavier copper keeps the voltage where it belongs and keeps the ends cool. On a hot afternoon under a heavy load it's worth putting a hand on the plug the first few times you use it, just to confirm everything's running cool, but that's good practice with any 50-amp connection.

Camco's PowerGrip name comes from the molded handles on the plug ends. Anyone who's tried to yank a stiff 50-amp cord out of a tight pedestal knows the ends take a beating. The grip handle gives you a real place to pull from, so you're not wrenching on the cord jacket or the blades themselves. It's a small thing that saves the connector over a lot of seasons.

There's also a carrying strap built in. A 15-foot run of 6-gauge cable is heavy, and it does not want to coil neatly. The strap lets you loop it up, cinch it, and carry the whole thing in one hand instead of wrestling a tangle across the campsite or the dock. Some folks pull the strap off after a while if it snags on cleats or hardware, but for hauling and storing it earns its keep.

The jacket is STW rated, the standard for this kind of portable power cable. It's flexible enough to route around a pedestal and tough enough to sit outside in the weather. One honest note. Like any STW cord, it stiffens up in the cold. Below about 40 degrees it gets noticeably harder to coil, so if you're plugging in on a frosty morning, give it a minute to relax or coil it loosely.

Fifteen feet is the sweet spot for most sites. It reaches the pedestal without leaving forty feet of cable to trip over. If your inlet sits far from the post, or you're at a slip where the pedestal is a good distance away, you may want a longer run or an extension. But for a typical pull-through or a well-placed dockside post, 15 feet keeps things clean.

Who's this for? Anyone with a 50-amp NEMA 14-50 inlet who wants a cord that'll last. That's most larger RVs, fifth wheels, and toy haulers, plus any rig or dockside setup wired for 14-50 50-amp service. If your rig is 30-amp, this isn't your cord. You'd want a 30-amp TT-30 cord instead. And this is a straight power cord, not a surge protector or an adapter, so match the connector to your pedestal before you buy.

A couple of care habits go a long way. Keep the female end covered when it's stored, because the ground pin and the contacts inside can corrode over a few seasons if they sit exposed to salt air or damp. And don't leave it half-plugged. A loose 50-amp connection heats up fast. Seat it fully, and if your pedestal supports it, a locking ring keeps it snug.

Bottom line, it's a straightforward, heavy-duty 50-amp cord from a name that's been building this kind of gear since 1966. Nothing fancy. Just the right gauge wire, handles that make it easy to live with, and a strap so you're not fighting it every time you set up or break down.