Camco 39625 Revolution 20-Ft RV Sewer Hose Kit

The Camco Revolution 20-foot sewer hose kit is the setup you want when you pull into a full-hookup site and just want the dump done right the first time. It's a complete kit. Two 10-foot hose sections, pre-attached swivel fittings on both ends, a translucent swivel elbow, a 4-in-1 dump station adapter, and four storage caps. Open the box, connect, and go.

The hose itself is 3-inch HTS vinyl at 15 mil thickness. That extra wall thickness matters more than people think. A thin sewer hose kinks the second you route it around a jack or a stabilizer, and a kink at a dump station is exactly the mess you don't want. The 15 mil vinyl holds its shape, resists crushing under the weight of a full flush, and takes the abuse of being dragged across gravel pads. Brown vinyl was a smart call too. It hides stains that show up glaring on lighter hoses.

What sets this kit apart is the pre-attached swivel fittings. Both ends of each hose section rotate a full 360 degrees. If you've ever fought a rigid fitting trying to line up the bayonet lugs on your RV's waste valve while holding a heavy hose at an angle, you know why this is a big deal. You just push the hose up to the connection, twist, and lock. The swivel takes the strain out of the joint so you're not cross-threading or forcing anything.

The elbow is where the everyday convenience lives. It's translucent, so you can actually see when the flow runs clear. No more guessing whether the black tank is truly empty before you back-flush or disconnect. When the water at the elbow goes clear, you're done. The elbow swivels too, which helps you seat it flat into the dump station inlet at whatever awkward angle your site gives you.

On the dump-station end you get the 4-in-1 adapter. It fits a 3-inch slip connection and 3-inch, 3-1/2-inch, and 4-inch threaded dump station pipes. That covers just about every public dump station, campground sewer inlet, and full-hookup pad you'll roll up to. The stepped design seats into the opening and gives you a sealed, hands-free connection so you're not standing there holding the hose down the whole time.

The two 10-foot sections give you flexibility most single-length hoses don't. Site sewer inlet close to your rig? Use one 10-foot section and leave the other capped in storage. Long pull to the connection, or an inlet on the wrong side of the pad? Link both together for the full 20 feet of reach. When you're done, the whole thing compresses down to 20 to 29 inches for storage, and the four included caps seal both ends of each section so nothing drips in your bumper storage tube or your utility bay.

This is a solid everyday sewer kit for travel trailers, fifth wheels, and motorhomes. If you camp at full-hookup sites regularly, the swivel fittings and clear elbow are the two features you'll appreciate every single dump. It's not a heated hose and it's not a permanent hardline, so if you're a winter full-timer you'll still want to think about freeze protection separately. For three-season camping and normal trips, though, this kit handles the job cleanly and packs away small. We like it as a first sewer kit for new RV owners and as a no-drama replacement when a cheaper hose finally splits on you.

Care is simple. Rinse the hose through after each dump, cap both ends, and store it compressed. Because the fittings are pre-attached and swivel rather than glue-on, there's nothing to assemble and no adapter that walks off between trips. Keep the caps on and the next hookup is as clean as the first.