Rule LoPro 900GPH Bilge Pump - Non-Automatic

Our latest automatic pump design, the LoPro allows for pumping out of tight spaces and shallower bilges. The e LP900D model uses a unique double system for sensing water, to ensure that the pump only ever operates when water is present, and switches off efficiently when it’s not. If water is sensed, the pump will spin the impeller as a double check. If water is confirmed, the pump will run to empty the bilges. The pump body rotates to allow discharge in any direction. A selection of straight and 90 degree ports, and a non-return valve for use with straight ports, are supplied.

Rule LP900D Attributes

• Type: Submersible
• Voltage Rating: 12 Volt DC
• Flow Rate: 900 Gallon Per Hour
• Length: 2.4 Inch
• Width: 2.4 Inch
• Height: 7.6 Inch

Rule LP900D Features & Benefits

• Features Two Automated Modes Of Operation
• High Or Low Water Sensing Mode The Pump Starts When Water Reaches 2 Inch By Turning The Motor Cartridge Upside Down, The Sensor Is At 1.3 Inch
• Electronic Automatic Mode The Pump Automatically Turns On Every 2.5 Minutes To Check For Water, And If It’s Detected The Pump Stays On Until The Water Is Gone
• Fully Rotating Discharge Body; The Entire Body Swivels Up To 180 Degree, Making The Pump Extremely Easy To Install
• Backflow Prevention; New Tricuspid Check Valves Help Prevent Backflow
• Horizontal Or Vertical Mounting; Feature A Variety Of Mounting Options To Accommodate The Boat’s Bilge
• Limited 3 Year Warranty

Rule LP900D Installation Instructions

• lp900d-instruction-manual2.pdf

Rule LP900D Technical Bulletins

• lopro-bilge-pumps-sales-flyer.pdf

LoPro 900GPH Bilge Pump - Non-Automatic

The Rule LoPro™ 900 non-automatic is a low profile Bilge Pump with a 900 gallons per hour capacity. Designed for tight spaces, the height of the pump is only 2-1/4".
It features a threaded discharge nozzle to which you can attach either a straight or a 90° fitting (included). In addition, you may use the tricuspid check valve {included} on the straight fitting to minimize the back flow of water. The entire discharge body swivels up to 180° for ease of installation. The hose attached can also swivel 360° to route the hose perfectly.

Features:

• 900 GPH Low Profile Bilge Pump
  
• Fits into hard to reach places
  
• Non-automatic, requires float and or panel switch to automate
  
• Threaded discharge ports with mulitiple fittings available
  
• Features a tricuspid check valve to minimize back flow of water

WARNING: This product can expose you to chemicals including STYRENE which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

Lopro 900gph bilge pump-non-automatic rules The lopro 900 non-automated is a low-profile bilge pump with a processing capacity of 900 gallons per hour. Designed for small spaces, height...
SKU: NVN-54195
MPN: LP900D
UPC: 042237114365